Abstract:Cryo-rolled aluminum alloys have a much higher strength-to-weight ratio than cold-rolled alloys, which makes them invaluable in the aerospace and automotive industries. However, this strength gain is frequently accompanied by a formability loss. When uniformly applied to the blank surface, hydroforming provides a solution by generating geometries with constant thickness, making it possible to produce complex structures with "near-net dimensions", which are difficult to achieve with conventional approaches. This study delves into the cavity die sheet hydroforming (CDSHF) process for high-strength cryo-rolled AA5083 aluminum alloy, focusing on two primary research questions. Firstly, we explored the utilization of a nonlinear 3D finite-element (FE) model to understand its impact on the dimensional accuracy of hydroformed components within the CDSHF process. Specifically, we investigated how decreasing fluid pressure and increasing the holding time of peak fluid pressure can be quantitatively assessed. Secondly, we delved into the optimization of process parameters—fluid pressure (FP), blank holding force (BHF), coefficient of friction (CoF), and flange radius (FR)—to achieve dimensional accuracy in hydroformed square cups through the CDSHF process. Our findings reveal that our efforts, such as reducing peak fluid pressure to 22 MPa, implementing a 30 s holding period, and utilizing an unloading path, enhanced component quality. We demonstrated this with a 35 mm deep square cup exhibiting a 16.1 mm corner radius and reduced material thinning to 5.5%. Leveraging a sophisticated nonlinear 3D FE model coupled with response surface methodology (RSM) and multi-objective optimization techniques, we systematically identified the optimal process configurations, accounting for parameter interactions. Our results underscore the quantitative efficacy of these optimization strategies, as the optimized RSM model closely aligns with finite-element (FE) simulation results, predicting a thinning percentage of 5.27 and a corner radius of 18.64 mm. Overall, our study provides valuable insights into enhancing dimensional accuracy and process optimization in CDSHF, with far-reaching implications for advancing metal-forming technologies.

Analysis and Design of Hydroforming Process for Automobile Rear Axle Housing by Fem

Analysis and design of hydroforming process for automobile lower arm by FEM

Rigid–plastic finite element analysis of hydroforming process and its applications

Analysis and Design of Hydroforming Processes by the Rigid–plastic Finite Element Method

Preform design in hydroforming of automobile lower arm by FEM

Rigid-plastic finite element method and its implementation in the hydroforming processes

Manufacture of an Automobile Lower Arm by Hydroforming

Analysis and experiment on tube hydroforming in a rectangular cross-sectional die

Finite element analysis of hydroforming process for sheet metal pairs

Prediction of forming limit in the hydroforming processes by using FEM and fracture criterion

Research on the hydroforming law of variable cross-section shaped tubular automobile longitudinal arm

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Influence of Process Parameters on Thinning Ratio and Fittability of Bellows Hydroforming

Analysis of Forming of Automotive Drawbar and Design of the Die

Design of Hydraulic Bulging Die for Automobile Torsion Beam and Optimization of Forming Process Parameters

Effects of preform on thickness distribution of hydroformed Y-shaped tube

Application and development of algorithm for sheet hydro-forming in numerical simulation

Development of an FEM for the Combined Electromagnetic and Hydraulic Forming Process Based on Experimental Data

A 3D Non-Linear FE Model and Optimization of Cavity Die Sheet Hydroforming Process

Structural analysis of plate-type hydroforming hydraulic press