Abstract:Vehicle-to-everything (V2X) is considered a key factor in driving the future development of intelligent transport, which requires high-quality communication and fast sensing of vehicle information in high-speed mobile scenarios. However, high-speed mobility makes the wireless channel change rapidly, which requires frequent channel estimation and channel feedback between a vehicle and the roadside unit (RSU), resulting in an increase in communication overhead. At the same time, the high maneuverability of vehicles leads to frequent switching and misalignment of communication beams, so the RSU must have better beam prediction and tracking capabilities. To address this problem, this paper proposes an adaptive frame structure design scheme for sensing-assisted downlink (DL) communication. The basic idea of the scheme involves analyzing the communication model during the vehicle's movement. This analysis aims to establish a theoretical relationship between the Symbol Error Rate (SER) and the following two key factors: the vehicle's starting position and the distance it travels across. Subsequently, the scheme leverages the vehicle's position data, as detected by the RSU, to calculate the real-time SER for DL communication. The SER threshold is set based on the requirements of DL communication. If the real-time SER is below this threshold, channel estimation becomes unnecessary. This decreases the frequency of channel estimation and frees up time and frequency resources that would otherwise be occupied by channel estimation processes within the frame structure. The design of an adaptive frame structure, as detailed in the above scheme, is presented. Furthermore, the performance of the proposed method is analyzed and compared with that of the traditional communication protocol frame structure and the beam prediction-based frame structure. The simulation results indicate that the communication throughput of the proposed method can be improved by up to 6% compared with the traditional communication protocol frame structure while maintaining SER performance.

Physical Layer Frame Structure Design and Implementation in SC-UWB System

Frame Design of SC-FDE System for Noise Suppression Used in UAV Data Link

Introduction of SC-UWB proposal

Performance of Intra-Chip Wireless Interconnect Using On-Chip Antennas and UWB Radios

Physical Layer Design For Dvb-S2 Ccm Mode

Power allocation for multi-band OFDM UWB communication networks

Research on Adaptive Transmission of Time Division Duplex Physical Frame in Mobile Satellite System

SC-UWB: A low-complexity UWB technology for portable devices

A Hardware Implementation Solution for DC-OFDM-based UWB PHY

Flexible Platform Design of IEEE 802.15.3a MAC over UWB with Optimized Protocol Accelerator

Implementation of Adaptive Spatial Field Digital Modulation System Without Phase Measurement

Design and Implementation of Wireless UWB Video Monitor System

Design of Compatibility Interleaver in Ultra Wide Band Wireless Communication System

A resource preserved MAC protocol for QoS provided UWB ad hoc networks

Design and Implementation of Mac and Phy of A Sub-Ghz Wireless Transmission Protocol Using Software Defined Radio Platform

Design and Implementation of the Physical Layer Control System Based on TD-LTE Baseband Chip

Adaptive Frame Structure Design for Sensing-Assisted Downlink Communication in the Vehicle-to-Infrastructure Scenario

Simulation of Single Carrier Ultra-Wideband System Based on SystemVue

Design and implementation of a physical layer optical fiber security communication system based on a ZUC stream cipher

Implementation of Low-complexity for (De)-Interleaver in UWB System

Co-design of ESD Protection and UWB RF Front-End ICs