Abstract:Since 2002, ultra wideband (UWB) technology has ignited the interests of academia and industry for its potential of achieving high-speed wireless communication in short distance with low power. It is actively investigated today due to the wide available bandwidth for very high data rate up to 480Mb/s and low power service over short distances in 10m range. According to FCC (Federal Communications Commission), the frequency spectrum allocated for UWB is 3.1-10.6 GHz, and the spectrum shape of modulated output power and maximum power level are limited to -41.3dBm/MHz, which ensures that UWB can coexist with existing spectrum users like GSM(Global System of Mobile communication), WLAN(Wireless Local Area Network) and Bluetooth. Based on MB-OFDM(Multi-Band Orthogonal Frequency Division Multiplexing), WiMedia released the initial version of Physical Layer (PHY) Specification in September 2005. In this proposal, the UWB frequency spectrum from 3.1 GHz to 10.6 GHz is divided into 14 channels with 528MHz for each channel. These sub-bands are grouped into five band groups. It is seen that by increasing the signal bandwidth significantly, ultra-wideband achieves a high channel capacity and becomes an attractive solution to the ever-increasing data rate demands in wireless personal area networks (WPAN). In December 2005, European Computer Manufacturer's Association (ECMA) proposed the standard ECMA 368/369 on high-speed UWB physics layer and media access control layer based on MBOFDM scheme. This has pushed the industrialization of UWB technology to a new stage again. In China, UWB technology has also become a hot topic according to the issue of the UWB standard by Chinese Government in 2008. A new UWB scheme named dual carrierorthogonal frequency division multiplexing (DC-OFDM ) has been proposed and applied in China. In China standard, only the band from 6.2GHz to 9.4GHz and the band from 4.2GHz to 4.8GHz are available for UWB applications. These bands are partitioned into 14 subbands of 264MHz bandwidth which means the bandwidth is halved in China’s DC-OFDM standard compared with the ECMA 368/369 standard. Thus the sampling frequency of the DACs(Digital-to-Analog Converter) and ADCs(Analog-to-Digital Converter) are halved too. The power consumption of the system can be reduced greatly. Moreover, in DC-OFDM

SC-UWB: A low-complexity UWB technology for portable devices

Introduction of SC-UWB proposal

Performance of Intra-Chip Wireless Interconnect Using On-Chip Antennas and UWB Radios

UWB-over-Multimode-Fiber Technology for Short- Range Communication Networks

3 A 0 . 13 Um CMOS 6-9 GHz 9-Bands Double-Carrier OFDM Transceiver for Ultra Wideband Applications

A Fully-Integrated Cmos Uwb Transceiver for Ultra-Low-Power Short-Range Application

9.3 A 1mw 1mb/s 7.75-to-8.25ghz Chirp-Uwb Transceiver with Low Peak-Power Transmission and Fast Synchronization Capability.

Low power, non invasive UWB systems for WBAN and biomedical applications

Overview of Ultra-Wideband Transceivers—system Architectures and Applications

UWB transceiver circuits design for WPANs applications

A Pulse-Based Full-Band UWB Transceiver SoC in 0.18μm SiGe BiCMOS

Multi-Gbps Wireless Link by UWB: Chipset in CMOS from 6 GHz to 60 GHz

UWB Radio Module Design for Wireless Intelligent Systems-From Specification to Implementation

A Low Power Interference Robust IR-UWB Transceiver SoC for WBAN Applications

An MBOK-UWB SoC Transceiver in 0.181&#x03bc;m CMOS Technology

Ultra-Wideband Technology: Characteristics, Applications and Challenges

Design and Demonstration of Passive UWB RFIDs: Chipless Versus Chip Solutions

A Reconfigurable FM-UWB Transceiver for Short-Range Wireless Communications

Power allocation for multi-band OFDM UWB communication networks

Simulation of Single Carrier Ultra-Wideband System Based on SystemVue

A 7.5-Ghz Frequency-Hopping CDMA UWB Transceiver for Secure Multi-Sensor Connectivity