Abstract:Air flooding/air-foam flooding recovery technology has been attracting attention in oilfield development. The key point to the application of this technology is to ensure that the oxygen injected with the air can be fully dissipated inside the reservoir to lower the explosion risk in production wells and reduce the oxidation of the pipeline. It is generally believed that the oxygen and crude oil can react more in low-temperature-oxidation (LTO) reactions above 80 degrees C. As a large amount of oxygen would be spontaneously consumed at this temperature, this technology is mainly used in reservoirs where the temperature is greater than 80 degrees C. In the fractured low-permeability reservoir of China's Yanchang oilfield, where the reservoir temperature is only approximately 30 degrees C, a wide range of crude oil LTO would not be triggered theoretically. However, we found that the oxygen content of the associated gas in the gas channeling wells is significantly lower than that in the air. This phenomenon suggests that, there are other factors that could consume oxygen apart from the LTO reaction. To verify this assumption, an oxygen dissipation core flooding experiment at 30 degrees C and 80 degrees C was carried out to evaluate the oxygen consumption at different temperatures. At the same time, in order to determine the main controlling factors and dissipation mechanisms of oxygen dissipation, theoretical analyses and experimental studies were carried out from the aspects of reductive mineral oxidation reaction in the rock surface and formation water, the physical absorption of the micropore and the dissolution of the reservoir fluid. The results show that at the same experimental conditions, the oxygen consumption at 30 degrees C is 38.14% lower than that at 80 degrees C. The oxygen consumption factors in the low-temperature reservoir mainly include the chemical reactions between the oxygen and reducing minerals, dissolution and retention of formation water and oil, adsorption of Van der Waals forces in the reservoir and physical electronic adsorption of the hydrogen-sulfur bonds and carbon-sulfur bonds. In Chang 6 Reservoir of Ganguyi oilfield, formation water could theoretically consume 56 mg/L (1.75 mmol/L) oxygen through dissolved Fe2+. The dissolution by formation water could absorb 11.85 mmol/L oxygen (experimental value). The dissolution by oil could absorb 69.25 mmol/L oxygen (experimental test value), and the oxygen physical adsorption rate of rock pore surface was 1.26 mmol/L. Together with the pilot test data, the results show that the LTO reaction of the stratum crude oil barely occurs in the reservoir at low temperature (30 degrees C). However, a large amount of oxygen dissipation could still be achieved. This study demonstrates that air-foam flooding could break the applicable limit temperature and could also be applied in low-temperature reservoirs.

Experiment on Abiotic Factor Oxygen Consumption of the Reservoir

Experimental Study on Oxidation Reaction of Light Oil

Experimental on Oxidation Reaction Rate for EOR by Air Injection in Light-Oil Reservoirs

Experimental Study on the Safety of Exhaust Gas in the Air Injection Process for Light Oil Reservoirs

Research on oxidation characteristics and kinetics of light oil reservoir during the process of air injection

Effects of oxygen injection on oil biodegradation and biodiversity of reservoir microorganisms in Dagang oil field, China

A Study on Oxygen Consumption Mechanism of Air-Foam Flooding in Low-Temperature Oil Reservoir

Insights for Air Injection EOR from Static Oxidization Behaviours of Crude Oil

Evaluation of Low-Temperature Oxidation Analysis and the Development Effect of High-Pressure Air Injection in Low-Permeability Reservoirs

A Novel Insight of Laboratory Investigation and Simulation for High Pressure Air Injection in Light Oil Reservoir

Experimental Study on Low Temperature High Pressure Oxidation in Air Injection in Light Oil Reservoir

Regulation of geochemical activity of microorganisms in a petroleum reservoir by injection of H2O2 or water-air mixture

Numerical simulation study on enhanced oil recovery by air injection process in Shengli Oilfield

Numerical Simulation of Air Injection Low Temperature Oxidation in LowPermeability Reservoirs

Oil oxidation in the whole temperature regions during oil reservoir air injection and development methods

Laboratary experiment on efficiency of air injection displacement

Investigation on the Low Temperature Oxidation of Light Oil for Safely Enhancing Oil Recovery at High Temperatures and Pressures

A Numerical Simulation Investigation on Low Permeability Reservoirs Air Flooding: Oxidation Reaction Models and Factors

LTO laboratory experiments and reservoir selection criteria of air injection

Oxygen-carbon Dioxide Conversion Ratio in Air-light Oil Low Temperature Oxidation Process

Experimental Studies of Displacement Using Air Injection in Zhongyuan Oilfield