Abstract:Aqueous zinc ion batteries have been considered as the prominent candidate in the next‐generation batteries for its low cost, safety and high theoretical capacity. Nonetheless, formation of zinc dendrites and side reactions at the electrode/electrolyte interface during the zinc plating/stripping process affect the cycling reversibility of the zinc anode. Regulation of the zinc plating/stripping process and realizing a highly reversible zinc anode is a great challenge. Herein, we applied a simple and effective approach of controlled‐current zinc pre‐deposition at copper mesh. At the current density of 40 mA cm‐2, where the electron/ion transfers are both continuous and balanced, the Zn@CM‐40 electrode with the (002) crystal plane orientation and the compactly‐aligned platelet morphology was successfully obtained. Compared with zinc foil, Zn@CM‐40 exhibits greatly enhanced reversibility in the repeated plating/stripping (850 h at 1 mA cm‐2) for the symmetric battery test. A series of characterization techniques including electrochemical analyses, XRD, SEM and optical microscopy observation were used to demonstrate the correlation between the structure of pre‐deposited zinc layer and the cycling stability. The COSMOL Multiphysics modeling demonstrates a more uniform electric field distribution in Zn@CM than the zinc foil due to the aligned platelet morphology. Furthermore, the significant improvement is also achieved in a Zn||MnO2 full battery with a high capacity‐retention (87% vs. 47.8%). This study demonstrates that controlled‐current electrodeposition represents an important strategy to regulate the crystal plane orientation and the morphology of the pre‐deposited zinc layer, hence leading to the highly reversible and dendrite‐free zinc anode for high‐performance zinc ion batteries.

Experimental Study on the Zinc Electrodeposition Using Precipitated Zinc as Cathode

Electro-deposition experiment of electrolytic zinc rinsing wastewater

Zinc Deposition Characteristics on Different Substrates for Aqueous Zinc Ion Battery

Recycle and preparation of zinc used for zinc-air battery

RESEARCH ON KINETICS OF TREATMENT OF ELECTROLYTIC ZINC WASTEWATER BY ELECTRODEPOSITION

Influence of Cathodic Overpotential and Zincate Concentration on Zinc Deposition in Alkaline Solution

Uniform Zinc Electrodeposition Directed by Interfacial Cation Reservoir for Stable Zn-I2 Battery

Realizing Textured Zinc Metal Anodes through Regulating Electrodeposition Current for Aqueous Zinc Batteries.

Unraveling dynamical behaviors of zinc metal electrodes in aqueous electrolytes through an operando study

Structural effect of the zinc electrode on its discharge performance

Study of the performance of secondary alkaline pasted zinc electrodes

Highly Reversible Plating/Stripping of Porous Zinc Anodes for Multivalent Zinc Batteries

Bottom-Preferred Stripping Mechanism Towards Quantified Inactive Metallic Zn0-Dominant Zinc Loss in Rechargeable Zinc Metal Battery

Highly efficient zinc electrode prepared by electro-deposition in a salt-induced pre-phase separation region solution

The recovery of zinc from hot galvanizing slag in an anion-exchange membrane electrolysis reactor.

Realizing Highly Reversible Zinc Anode via Controlled‐current Pre‐deposition

Electrodeposition of Zinc from Galvanized Steel

Study Status of Anode Materials in Zinc Electrowinning

Electrodeposition of Zinc from Zinc Chloride-1-ethyl-3-methylimidazolium Chloride Molten Salt

Preparation of Nano-copper Modified Three-dimensional Zinc Mesh Electrode and Its Performance as Anode for Zinc-ion Batteries

Influence of Electrolyte Choice on Zinc Electrodeposition