Abstract:Microscale boiling heat transfer experiments were performed using acetone as the working fluid in ten parallel silicon microchannels with hydraulic diameters of 155.4 mum. An infrared radiator image system is used for the chip temperature measurements, while an optical system combining a microscope and a high-speed camera is used for transient flow pattern identification. By covering the present data range it is found that all microchannels repeat the transient flow patterns in a timescale of milliseconds while the fluid pressures/temperatures are stable. A full cycle can be subdivided into three substages: liquid refilling stage, bubble nucleation, growth and coalescence stage, and transient annular flow stage. Correspondingly four flow patterns are identified. Paired or triplet bubbles are observed to be nucleated and grow up simultaneously in, or very close to, the channel corners at the same cross section. The nucleated bubbles experience several milliseconds of growth until coalescence takes place. Then a single liquid plug is separated into two parts, which are pushed out of the flow field view in less than 1 ms. In the transient annular flow stage, the liquid films that are drawn into the comers of the channel become less and less versus time. Once a partially or fully dried-out state is reached, all the microchannels are refilled with fresh liquid and a new cycle begins. The probabilities of each flow pattern occurring and the liquid refilling follow the statistical principle well. The measured chip temperatures are not uniform across the whole heating area, attributed to the uneven liquid refilling probabilities for different channels and the uneven possibilities that are immersed in the liquid for different heating regions. The chip temperatures display spatial variation behavior in the majority of the heating area, due to the liquid and vapor alternatively passing through the microchannels. To the authors' knowledge, some of the above experimental findings have not been previously reported.

Boiling Regimes in Uncoated Polydimethylsiloxane Microchannels with A Fine Wire Heater

Bubble Dynamics During Boiling in Polydimethylsiloxane (PDMS) Microchannels with Wire Heater

Multi-Phase Pattern Evolution in Gas-Permeable Polydimethylsiloxane (pdms) Microchannels During Heating

Nucleate Boiling Bubble Dynamics in a PDMS Microchannel with a Single Nucleation Site

Capillary-Assisted Evaporation/Boiling in PDMS Microchannel Integrated with Wicking Microstructures

Flow Boiling in Vertical Narrow Microchannels of Different Surface Wettability Characteristics

Experimental Study Of Saturated Flow Boiling In Vertical Narrow Microchannel

Multiphase SPH Modeling of Water Boiling on Hydrophilic and Hydrophobic Surfaces

Visual Study of Flow Pattern Evolution of Flow Boiling in A Microtube

Subcooled flow boiling and microbubble emission boiling phenomena in a partially heated microchannel

Visualization and measurements of periodic boiling in silicon microchannels

Two Large-Amplitude/Long-Period Oscillating Boiling Modes in Silicon Microchannels

Effects of Heat Flux, Mass Flux, Inlet Fluid Subcooling, and Channel Orientation on Subcooled Flow Boiling in a High-Aspect-Ratio Rectangular Microchannel

Microscale Boiling and Microbubble Dynamics under Pulse Heating

Effects of pulse width and mass flux on microscale flow boiling under pulse heating

AN EXPERIMENTAL STUDY OF BUBBLE FORMATION ON A MICROWIRE COATED WITH SUPERHYDROPHOBIC MICROPATTERNS

Effects of Heat Flux, Mass Flux and Two-Phase Inlet Quality on Flow Boiling in a Vertical Superhydrophilic Microchannel

Microscale Boiling Heat Transfer in A Micro-Timescale at High Heat Fluxes

Jet Flows from Bubbles During Subcooled Pool Boiling on Micro Wires

Heat transfer, pressure drop and flow patterns of flow boiling on heterogeneous wetting surface in a vertical narrow microchannel

Effects of non-wetting fraction and pitch distance in flow boiling heat transfer in a wettability-patterned microchannel