Abstract:A Si(220) double-crystal monochromator for the energy range 10–30 keV is presented. It will be used for EXAFS as well as powder diffraction measurements. To determine the requirements for this monochromator we looked, apart from mean considerations, at the requirements dictated by EXAFS in transmission mode. For good data analyses the proper shape, amplitude, and location at the energy axis of each wiggle is required. Moreover it is essential to separate the wiggles from background and noise. For the latter a high flux through the sample is desirable, which can be achieved by horizontal focusing of the beam. For that we have chosen to bend the second crystal sagitally. The sagittal bending radius is adjustable between 50 and 0.8 m, because for different energies different sagittal radii are necessary to focus the beam on the sample. The mean meridional radius of the second crystal is fixed at 130 m, which is an optimization for 20 keV. The meridional radius of the first crystal can be tuned between 100 and 500 m. When this radius is set to 130 m the energy resolution is calculated to be 6, 3, and 35 eV for 10, 20, and 30 keV (for perfectly bent crystals). By changing the meridional radius of the first crystal, future users of this monochromator can make the trade off between resolution and intensity. Movement of the monochromator exit beam, during a scan, will occur due to the monochromator geometry, but is reduced as much as possible by using an asymmetrically cut second crystal, with an asymmetry angle of 2.5°. The average exit beam movement of the monochromator for a 1-keV scan is 20 μm. For 40% of the energy range (10–30 keV) the exit beam position remains within 10 μm. For the second crystal no translation stage is used. When using a translation stage it is difficult to keep the change in flux within acceptable limits, because an alignment error of 0.01 arcsec at 30 keV will result in a change in intensity of 1%.

X-Ray Beamlines at the Superconducting Wiggler of Nsrl

Design and Commission of A Superconducting Wiggler X-Ray Beamline for Advanced Materials Investigation at the National Synchrotron Radiation Research Center

Beam instrumentation system for shanghai soft x-ray fel test facility*

U7C Beamline and XAFS Station of National Synchrotron Radiation Laboratory.

Beam instrumentation system development and commissioning in ssrf

The New Infrared Beamline at NSRL

Introduction of the X-ray Diffraction Beamline of SSRF

Performance of the undulator based ultraviolet and soft x-ray beamline for catalysis and surface science at National Synchrotron Radiation Laboratory

A SMALL-ANGLE X-RAY SCATTERING STATION AT BEIJING SYNCHROTRON RADIATION FACILITY

The performance of X-ray diffraction and scattering endstation in NSRL and its typical applications in material science

Alignment of the photoelectron spectroscopy beamline at NSRL

X-ray microscopy instrumentation developments at NSLS-II: recent progress and future directions

A new experimental station for microbeam X‐ray scattering at the SSRF BL10U1 beamline

Construction and Recent Advances of the Surface Physics Beamline and Endstation of NSRL

The soft X‐ray spectromicroscopy beamline BL08U1A upgrade at SSRF

Experimental Station of Atomic and Molecular Physics at NSRL

GIWAXS experimental methods at the NFPS‐BL17B beamline at Shanghai Synchrotron Radiation Facility

A dynamic focusing x‐ray monochromator for a wiggler beam line at the SRS of the SERC Daresbury Laboratory (abstract)

Performance of the Atomic and Molecular Physics Beamline at the National Synchrotron Radiation Laboratory.

Biopharmaceutical beamline TLS 15A1 for macromolecular crystallography at the National Synchrotron Radiation Research Center

Monochromator development at 4W1B beamline of BSRF