Abstract:Pyrolysis shows potential as a resource treatment technology for municipal solid waste (MSW). In this paper, pyrolysis and combustion characteristics of typical MSW in constant temperature were investigated by reacting in a fixed bed electric heating furnace. First, the pyrolysis gas compositions of typical waste fractions such as paper, fabrics, kitchen rubbish, branches, plastics and rubber were investigated as a function of time at 750 °C. The results show that for different MSW components, reaching the peak of pyrolysis gas content spends a different time. The H 2 content increases with the increase of pyrolysis time, which indicates that the dehydrogenation reaction is more intense at the high-temperature stage, and a certain amount of hydrogen is precipitated when the large molecules are decomposed into small molecules. However, as a polymer compound, the H 2 content of rubber increases at the beginning of pyrolysis, but with the increase of time, the H 2 content begins to fluctuate and there is no obvious pattern. Secondly, the MSW was combined into by these typical components according to a certain proportion, and then the relationship of flue gas with temperature and excess air coefficient was studied using this MSW as fuel. The results show that NOx content of flue gas with the increased temperature, the increase amplitude is bigger, while with the increase of excess air coefficient, the increased amplitude is smaller. The SO 2 content of flue gas has a positive correlation with temperature and a negative correlation with excess air coefficient. This indicates that the use of lower temperatures and higher excess air coefficients can help to reduce pollutant gas emissions.

Experimental studies on municipal solid waste pyrolysis in a laboratory-scale rotary kiln

Study on Pyrolysis of Medical Waste in a Rotary Kiln:Typical Component under Batch Feeding

Experimental investigtion of paper mill sludge pyrolysis in the laboratory-scale rotary kiln

EXPERIMENT ON MANUFACTURE MEDIUMHEATING VALUE FUEL GAS BY PYROLYZING MUNICIPAL REFUSE IN A ROTARY KILN

Pyrolysis of Municipal Solid Waste in Rotary Kiln:Studies on Characteristics of Pyrolytic Tar

Experimental study on gas field for wood chip pyrolysis in rotary kiln

Analysis on low-temperature polyethylene pyrolysis and gasification in different atmospheres

Pyrolysis of solid waste in a rotary kiln: influence of final pyrolysis temperature on the pyrolysis products

Study on the pyrolysis and combustion characteristics of municipal solid waste in a fixed bed

Investigation of pyrolysis of waste plastics in a rotary kiln - influence of final pyrolysis temperature on pyrolysis products

Pyrolysis of the biomass wastes pyrolysis in a rotary kiln ⅰ:influences of reaction conditions on pyrolysis product distribution

Test study on batched high temperature pyrolysis of some msw

Experimental and Kinetic Modeling of Oxygen-Enriched Air Combustion of Municipal Solid Waste.

Pyrolysis characteristics of organic components of municipal solid waste at high heating rates.

Study on the pyrolysis characteristics of the mixture of typical organic components of MSW

The effects of temperature on continuous pyrolysis of combustible components in municipal solid waste

Municipal Solid Waste Pyrolysis under Circulated Pyrolytic Gas Atmosphere

Solid Waste as a Renewable Source of Energy: A Comparative Study on Thermal and Kinetic Behavior of Three Organic Solid Wastes

Pyrolysis Experiment of Refuse Derived Fuel and Study on Characteristics of Semi-Coke

Study on Pyrolysis and Gasification of Wood in MSW

Investigation on Thermal and Kinetic Characteristics During Pyrolysis and Co-Pyrolysis of Recovered Fuels Obtained From Municipal Solid Waste in China