Abstract:This paper introduces a compact picosecond laser system using tapered double cladding fiber-single crystal fiber hybrid amplification technology for the first time. By modifying the Ginzburg-Landau equation, we established a simulation model and designed a passive mode-locked picosecond oscillator based on a semiconductor saturable absorber mirror. The oscillator outputs laser with a pulse width of 7.75 ps, a center wavelength of 1030.55 nm, and a spectrum width of 0.58 nm. The seed laser is stretched and amplified by the all-fiber front stage, and then injected into the tapered double cladding fiber-single crystal fiber hybrid amplifier. The laser power is amplified from 820 mw to 103.1 W, obtaining a gain of 21 dB. We used zero-phonon line pumping technology in single crystal fiber amplifier to reduce the thermal effects caused by quantum loss, thereby increasing the length of the crystal and increasing the power loading capacity. We designed a single crystal fiber amplification module using Yb:YAG with 60 mm long, 1 mm diameter and a 1 at.% doping rate for the first time. Finally a hundred-watt level picosecond laser output with a repetition frequency of 26.33 MHz, an average power of 103.1 W, a pulse width of 244.72 ps, a spectrum width of 1.16 nm, and a beam quality of M2 x = 1.368 and M2 y = 1.511 was obtained. To the best of our knowledge, this is the highest picosecond laser output power for an all-fiber front-stage combined with a single-stage single crystal fiber amplifier.

Compact High-Power Multiwavelength Photonic-Crystal-fiber-based Laser Source of Femtosecond Pulses in the Infrared–visible–ultraviolet Range

3 GHz, Yb-fiber laser-based, few-cycle ultrafast source at the Ti:sapphire laser wavelength

Compact and High-Power Broadband Terahertz Source Based on Femtosecond Photonic Crystal Fiber Amplifier

Compact hundred-watt level picosecond laser system based on tapered double cladding fiber-single crystal fiber hybrid amplifier

Intense Two-Octave Ultraviolet-Visible-Infrared Supercontinuum Laser via High-Efficiency One-Octave Second-Harmonic Generation

3-Ghz, Ultrafast Yb-fiber Laser Sources: Closing the Spectral Gaps

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.

An Experimental Study Of Ultrashort Pulsed Ytterbium-Doped Fibre Laser And Amplifier

Research on ytterbium-doped photonic crystal fiber amplifier for the femtosecond fiber laser

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

391 Μj Picosecond Ultraviolet Pulses at 355 Nm with 1 MHz Repeat Rate

Demonstration of an Ultraviolet Stimulated Brillouin Scattering Pulse Compressed Hundred Picosecond Laser in LiB3O5 Crystals

An efficient high-power femtosecond laser based on periodic-layered-Kerr media nonlinear compression and a Yb:YAG regenerative amplifier

Broadband High-Power Mid-Ir Femtosecond Pulse Generation from an Ytterbium-Doped Fiber Laser Pumped Optical Parametric Amplifier

Femtosecond Cr:forsterite Laser Diode Pumped by a Double-Clad Fiber.

Toward 5.2 Mu M Terawatt Few-Cycle Pulses Via Optical Parametric Chirped-Pulse Amplification With Oxide La3ga5.5nb0.5o14 Crystals

A Compact 51.6-W, 26-Μj, Yb-doped All-Fiber Integrated CPA System Through Quasi-Rectangular Pulse Pre-Shaping

39.1 μJ picosecond ultraviolet pulses at 355 nm with 1 MHz repeat rate.

3 GHz few-cycle ultrafast source at 850nm

Fiber-Based High-Energy Femtosecond Pulses Tunable from 920 to 1030 Nm for Two-Photon Microscopy

High-power 355 Nm Ultraviolet Lasers Operating at Ultrahigh Repetition Rate