Abstract:A series of dynamic axial tensile tests were performed on concrete and its three components using a servo-hydraulic testing machine. The dynamic mechanical properties of approximately 200 specimens were tested under a dynamic load at strain rates that ranged from 10 to 10(-2) s(-1), different initial static loads, and cyclic variable-amplitude loads with different frequencies. The results indicated the following: 1) tensile strength is sensitive to strain rate in all these materials and the rate sensitivity of strength for concrete was close to the composite material with the lowest sensitivity factor k; 2) the elastic modulus is less sensitive to strain rate than strength in all the materials. The rate sensitivity of the modulus for concrete was close to its component material with the lowest sensitivity factor m. The interfacial transition zone (ITZ) had the highest m among the composites; 3) the stress-strain relation for mortar is almost completely linear before peak stress. In contrast, the stress-strain relations of the concrete, granite, and interface appear nonlinear when the stress is set at more than approximately 50% of the peak value, and the nonlinear section showed a linear trend with increasing strain rate; 4) an initial static load within certain limits increased the dynamic tensile strength. The critical initial static loads for the mortar, granite, interface, and concrete were 70%, 50%, 50%, and 30%, respectively; and 5) the cyclic loading history had the least influence on the mortar and the most influence on the interface. The influence of fatigue damage decreased when the loading frequency increased.

Experimental study of dynamic axial tensile constitutive relationship for mortar

Experimental Study on Dynamic Axial Tensile Mechanical Properties of Concrete and Its Components

Experimental Study on Dynamic Tensile Strength of Cement Mortar Using Split Hopkinson Pressure Bar Technique

Quasi-static and Dynamic Experimental Studies on the Tensile Strength and Failure Pattern of Concrete and Mortar Discs

Experimental study on dynamic compressive properties of concrete

Experimental Research on Static and Dynamic Characteristics of Cement Soil under Strain Control

Quantification of Dynamic Tensile Behavior of Cement-Based Materials

Stress-Strain Behavior and Statistical Continuous Damage Model of Cement Mortar under High Strain Rates

Experimental Study on the Dynamic Compressive Properties of Concrete and the Application Analysis

Study on Axial Tensile Strain Rate Effect on Concrete Based on Experimental Investigation and Numerical Simulation

Influence of Loading Rate on Mechanical Properties of Cement Asphalt Mortars

Experimental study on concrete under dynamic tensile loading

Dynamic response of brittle material cement mortar under multi-axial stress

Experimental Research of Strain Rate on Compressive Property Effects of Concrete

Effect of Strain Rate on Compressive Behavior and Modeling of Cement and Asphalt Mortar

Experimental and Mesoscopic Study of Dynamic Tensile Properties of Concrete Using Direct-Tension Technique

Rate Sensitive Damage Behavior of Mortar in Compression

Difference in Dynamic Direct Tensile Failure Mechanism Between Homogeneous Mortar and Three-Dimensional Mesoscopic Concrete Based on the Split Hopkinson Tension Bar

Uniaxial Compression Behavior Of Cement Mortar And Its Damage-Constitutive Model Based On Energy Theory

Effects of Moisture Content on the Cyclic Behavior of Crushed Tuff Aggregates by Large-Scale Tri-Axial Test

Dynamic compressive and splitting tensile tests on mortar using split Hopkinson pressure bar technique