Abstract:The characteristics of the interface are the key factors that determine the mechanical properties and fracture behavior of fiber-reinforced ceramic matrix composites. Design and preparation of coatings which can preserve fiber strength and maintain appropriate interfacial bonding strength are of great challenges. LaPO4 coating is a promising weak interface coating for oxide fiber reinforced oxide ceramic matrix composites. Through this coating, the toughening mechanism of the composite such as fiber pulling out and fiber debonding is triggered. The LaPO4 coating was deposited on the surface of alumina-based fibers by a solution precursor heterogeneous precipitation method. The effects of different precursors and different deposition temperatures on fiber strength were studied, and the mechanism of the strength degradation of the coated fiber was analyzed. It was found that the fibers coated with phytic acid precursor and deposited at 90 °C had the highest tensile strength compared to other coated fibers. The retention of strength is attributed to its loosely stacked coating. Besides, a single fiber pullout test was carried out to evaluate the effect of the coating on the interface of the composites. The results show that the composites coated by depositing citric acid precursor and phytic acid precursor at 90 °C can reduce the interfacial bonding strength by 32.5% and 46.7%, respectively compared to uncoated composites. This study has potential application value in the preparation of ceramic matrix composites used in oxidation and high temperature environments.

Synthesis and sintering of LaPO4 powder and its application

Mechanical Properties and Microstructure of Layered LaPO; Ceramics

Effect of LaPO4 content on the microstructure and machinability of Al2O3/LaPO4 composites

Properties and microstructure of machinable Al2O3/LaPO4 ceramic composites

Mechanical Properties and Microstructure of Layered Lapo4 Ceramics

Mechanical Anisotropy in LaPO4 Ceramics

Preparation and Properties of Perovskite La1-xSrxCoO3-delta Powders and Ag-LSCO Electrical Contact Composite Materials

Microstructure and mechanical properties of machinable Al2O3/LaPO4 composites by hot pressing

Electrodeposition of high aspect ratio LaPO 4 and LaPO 4 :Ln 3+ (Ln 3 + =Ce 3+ , Tb 3+ ) nanostructures

Synthesis and electrical properties of apatite-type La10Si6O27

Enhanced Mechanical Properties Of Machinable Lapo4/Al2o3 Composites By Spark Plasma Sintering

Design, Fabrication and Characterization of Machinable Al<sub>2</sub>O<sub>3</sub>/LaPO<sub>4</sub> Functionally Graded Materials

Effects of LiF-Addition on Sintering Behavior and Dielectric Response of LaPO4 Ceramics at Microwave and Terahertz Frequency for LTCC Applications

Synthesis of Mesoporous Lapo4 Nanostructures with Controllable Morphologies

Preparation of Mesoporous La2Sn2O7 Powder and Ag-La2Sn2O7 Electrical Contact Composite Materials and Their Properties

Effect of La-Introduced Manner on the Phase Formation and Morphology of the Hydrothermally Synthesized Pb_(0.70)La_(0.30)TiO_3 Powders

Farbrication and Properties of Machinable Al<sub>2</sub>O<sub>3</sub>/LaPO<sub>4</sub> Composites and FGMs

Effects of Processing Parameters of Sps on the Densification and Texture of Lapo4 Ceramics

Synthesis of SrLaAlO 4 Fine Ceramic Powders by Co-Precipitation Process

Sintering and microwave dielectric properties of LiCaPO4 ceramic: experiment and first principle calculation

LaPO4 coating on alumina-based fiber: Strength retention of fiber and improvement of interfacial performances