Abstract:Porous structures are ubiquitous in many thermal management and energy conversion systems. The morphology of a porous structure has significant impact on the fluid flow, heat/mass transport, and strength performance. However, the available fabrication techniques are not capable of directly tailoring porous structures with well-controlled pore features and functional graded pore morphology, thereby limiting the performance enhancements for these systems. In this study, a triply periodic minimal surface (TPMS) based method was developed to customize the morphology of porous media with well-controlled pore features and to fabricate these parts with additive manufacturing. Porous structures with designed pore parameters were built based on the mathematically defined iWP surface, primitive surface, diamond surface and gyroid surface. Before performing flow and heat transfer simulations, morphological analysis was conducted to establish the connections between the geometrical parameters and the performance of the porous structure (flow resistance, heat transfer, and strength). The porous structures were compared in terms of their structural strength, specific pressure drop, interstitial/volumetric heat transfer coefficients and the ratio of the Colburn factor relative to the friction factor. The TPMS porous structures indicated that much higher strength than the simple cubic packing structure (approximation of sintered metal particles) due to their reasonable struct connectivity. Computations demonstrated that the type P structure had the lowest flow resistance and highest comprehensive heat transfer coefficient (j/f). The high specific surface area, continuous changes in the flow direction, periodic mixing/redistribution and flow acceleration contributed to the higher volumetric heat transfer coefficients in the type W/G structures.

Formation Mechanism of Porous Grooves on Tube Walls by Ploughing-Heat Treatment

Ploughing-Pulling Forming for Wicking Structure of Flat Micro-Groove Heat Pipe and Machine Tool Optimization

Groove deformation analysis of a single plough on inner copper tube

Ploughing-extrusion Experiment Study of Pore-Groove Enhanced Boiling Structure

Enhancement of Pool Boiling Heat Transfer on Porous Surface Tube

Progress of Passive Enhanced Heat Transfer Tubes

Internal Flow Analysis of a Heat Transfer Enhanced Tube with a Segmented Twisted Tape Insert

Design, Simulation and Fabrication of A Silicon Micro Flat Heat Pipe with Axial Triangle Grooves

Study on Heat Transfer Enhancement by Filling Tube Inner Part with Two Layers of Porous Media

Numerical and Experimental Study of Pool Boiling Heat Transfer Mechanisms in V-shaped Grooved Porous Metals

Tubes with Coated and Sintered Porous Surface for Highly Efficient Heat Exchangers

Visualization Study on the Enhancement of Heat Transfer for the Groove Flat-Plate Heat Pipe with Nanoflower Coated CuO Layer

Influence of key geometry parameters on heat transfer and flow resistance properties of toothed internal spiral piece cracking furnace tube

Metal Flow Hysteresis Behavior and Shape Control Strategy During Porthole Die Extrusion of Micro Heat Pipe

Characteristics of a Micro Flat Heat Pipe with Trapezoidal Grooves

Fabrication and Testing of SOG Structure Flat Heat Pipes with Triangle Grooves

Experiments on Fluid Flow and Heat Transfer in a Packed Channel Between Two Parallel Grooved Plates

Design and Experimental Analysis of Grooved Flat Aluminum Heat Pipe

Influence of Feed on Spiral Inner Grooves Formation with Ploughing

Morphology, Flow and Heat Transfer in Triply Periodic Minimal Surface Based Porous Structures

Investigation on the flattening process of micro-grooved circle tube for enhanced heat transfer