Abstract:The present paper reported numerical analyses and experimental studies on fluid flow and heat transfer for laminar film condensation on various grooved surfaces. Different from the previous literatures, the coupled non-linear governing equations for the fluid flow, mass transfer and two-dimensional thermal conduction were developed base on some reasonable assumptions. Through analyzing the influences of groove shape parameters on film thickness and heat flux, we found that both of them were significantly influenced by the pitch, height and profile radius of the groove. The velocity distributions on the condensate -vapor interface and distributions of wall temperature on various grooves were also studied systematically. The calculations indicated that the surface tension gradient of the liquid film drove the liquid to flow from the crest into the trough. The horizontal velocity decreased first and then increased gradually on the crest and reached a maximum value on profile, and then decreased to zero in the trough region. On the contrary, the condensate flowed at very low vertical velocities on the crest and profile of groove, but in trough region these velocities increased rapidly to a relatively high level. The results of comparison showed that both the distributions of wall temperature and heat flux on involute groove were more favorable to reduce thermal resistance and enhance heat transfer than other grooves. In order to validate the feasibility and reliability of the present analyses, experiments were carried out with some involute grooved surfaces for various physical dimensions, a trapezoid grooved surface and a smooth surface respectively. Both the numerical results and experimental data indicated that involute groove can provide a better heat transfer performance, and the heat flux of involute grooved surface was at least 20% and 50% higher than that of trapezoid grooved and rectangular grooved surfaces. The present analyses were feasible, and could be used in the parameter design and heat transfer calculation of involute grooved surfaces as well as trapezoid grooved surfaces. (C) 2016 Elsevier Ltd. All rights reserved.

Investigation on the flattening process of micro-grooved circle tube for enhanced heat transfer

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Inner Surface Morphology and Roughness Evolution of Pilgering Thick-Walled Tubes

Progress of Passive Enhanced Heat Transfer Tubes

An Experimental Investigation of Groove Control for Reducing Drag in a Flat Turbulent Boundary Layer

Investigation of cold drawing process of thin-walled ribbed steel tube

Evolution of microstructure, microhardness and surface roughness of Al alloy thin-walled tube during flaring process

Mechanical Performance of Multi-Cell Thin-Walled Tubes under Static and Dynamic Axial Loading

Research on Flattening Behavior of Wrinkled 5A02 Aluminum Alloy Tubes under Internal Pressure

Numerical and experimental study on in-plane bending of microchannel aluminum flat tube

Plastic wrinkling of thin-walled tubes under axial compression in non-uniform temperature field

Comparative Study on Destructive Performance and Energy Absorption of Aluminum Tube by Simulation and Experiment

Formation Mechanism of Porous Grooves on Tube Walls by Ploughing-Heat Treatment

Numerical and Experimental Study on Expansion Forming of Inner Grooved Tube

Enhancement of Condensation Heat Transfer on Grooved Surfaces: Numerical Analysis and Experimental Study

Ploughing-Pulling Forming for Wicking Structure of Flat Micro-Groove Heat Pipe and Machine Tool Optimization

Experimental and numerical study of the flaring process for Zircaloy tube end

A Visual Experimental Study on Surface Temperature Field in Stainless Steel Microtube

The Deformation Behavior and Microstructure Evolution of Cladding Tube during Spinning Composite Process of Mg/Al Tube

Analysis of the wall thickness distortion in tube hydro-forging

A Generalized Thermal Deviation Factor to Evaluate the Comprehensive Stress of Tubes under Non-Uniform Heating