Abstract:During production, significant differences were observed between the center and surface composition of the transition bloom, posing challenges in accurately determining its location. To address this issue, we developed a three-dimensional (3D) multiphysics coupled numerical simulation of the steel grade transition. This simulation is based on fluid–solid–thermal–magnetic and solute transportation models, encompassing the entire process from the ladle nozzle to the solidification endpoint. In contrast to prior studies that treated new and old grades as distinct components, our approach regards each element as an individual component, enabling the investigation of the specific segregation behavior of each element. By simultaneously accounting for the effects of flow and segregation on the composition of the transition bloom, our proposed model offers a clear understanding of the distribution of solute elements within the bloom. Moreover, our model exhibits higher prediction accuracy compared to previous approaches used for steel grade transitions. The research findings indicate that assigning a steel grade with higher density and lower solute element content as the old grade, and a steel grade with lower density and higher solute element content as the new grade, results in a transition bloom length of 24.70 m. Conversely, when the casting sequence is reversed, the length of the transition bloom increases to 33.44 m. Therefore, our new model provides a theoretical basis for reducing the length of the transition bloom. By implementing a well-planned casting sequence for the steel grade transition, substantial reductions in the length of the transition bloom can be achieved, leading to significant cost savings in production.

A Study and Application of Batcher Drip Nozzle Used for Casting Metal Grains

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Controlling the Electric Field Characteristics to Suppress the Clogging and Corrosion of the Continuous Casting Nozzle

Research on the Corrosion Behavior of Low Carbon Mold Flux on Submerged Nozzle Refractory

Investigation of Granulated Metal Fabricated by Short Flow Casting Technology

Prediction and Optimization of Water Flux Distribution for Flat Nozzles in Slab Continuous Casting

Physical and Numerical Simulation Study on Structure Optimization of the Inner Wall of Submerged Entry Nozzle for Continuous Casting of Molten Steel

Effect of centrifugal casting process on mold filling and grain structure of K418B turbine guide

Analysis and Optimization of Spray Nozzles Arrangement in Slab Casting by Numerical Simulation

Effect of droplet characteristics on liquid-phase distribution in spray zone of internal mixing air-mist nozzle

Three-dimensional FEM Study of Fluid Flow in Mould for Beam Blank Continuous Casting: Influence of Nozzle Structure and Parameters on Fluid Flow

A New Porous Nozzle for Aluminum Melts Purification—Preparation and Mathematical–Physical Model

The Effect of Steel Grade Casting Sequence on the Length of Transition Bloom

Fluid Flow in Continuous Casting Mold with a Configured Nozzle

Optimization of submerged entry nozzle parameters for ultra-high casting speed continuous casting mold of billet

Preliminary Study on Deformation Behaviors of Spray Droplet Impacting on Nonrigid Deposited Layer

Research on the Forming Mechanism of Micro/Nano Features During the Cast Molding Process

Research on Casting Process for Embedded Internal Flow Passage Mould

Comparison of the Flow Field in the Slab Continuous Casting Mold Between the Two- and Three-Hole Nozzles with High Temperature Quantitative Velocity Measurement and Numerical Simulation

Simulation and Optimization of Casting Technique on Upper Beam of 80MN Rapid Forging Press

Study and Application of Mold Filling Simulation of Shaped Castings