Abstract:Preforms were made from 1K PAN plain carbon cloth and densified using the rapid directional diffusion chemical vapor infiltration (RDD CVI) processes. Four carbon/carbon (C/C) composite specimens treated at 1800 (specimen A), 1800+2000 (B), 2000 (C), and 2300 °C (D), respectively, were prepared, then machined into ring-on-ring specimen configurations. The influence of high-temperature heat treatment and the test temperatures on the static friction properties of the C/C composites has been researched. The results show that the high-temperature heat treatment processes has an important impact on the static friction behaviors of RDD CVI C/C composites. With raising the treatment temperature, the interlayer spacing of the matrix carbon in them becomes small, and the crystallite width as well as height increase. Under the test at room temperature, the static friction coefficients (FC) of the specimen treated at 1800 °C (A) are the lowest, but become very big and the highest under the test temperature of 260 °C due to desorption of the water absorbed on the friction surface. The composites treated at 2000 °C (C) exhibit enough high static friction coefficients under room temperature owing to their absorption of less water and the difficult delamination of the matrix carbon. However, in the test temperature of 260 °C or after the dynamic friction tests, their static FC is low. The specimen treated at 2300 °C (D) has a low FC at 260 °C heat condition, but its FC is higher than that of A and C under room temperature and largest after dynamic friction tests. No matter how high the heated temperatures are, the static FC of C/C composites decreases with an increase of the brake-specific pressure. When the specific pressure is very high and exceeds a certain value, the static FC is almost the same for specimens B, C, and D.

Research on Thermal Diffusivity and Specific Heat Capacity of C/C Composites

Fabrication of Three-dimensional Thermally Conductive Carbon Fibers/Carbon Nanotubes Network Reinforce Epoxy Composites

A Numerical Study on the Thermal Conductivity of 3D Woven C/C Composites at High Temperature

THERMAL PROPERTIES AND MECHANICAL PROPERTIES OF DENSITY GRADIENT CARBON/CARBON COMPOSITES

Preparation, microstructure and properties of three-dimensional carbon/carbon composites withhigh thermal conductivity

Analysis of transverse thermal conductivity for mesophase pitch-based carbon fibers and the through-thickness heat conduction of their composites

EFFECTS OF FABRIC ARCHITECTURES ON THE THERMAL EXPANSION COEFFICIENT AND THE THERMAL DIFFUSIVITY OF CARBON FIBER REINFORCED SILICON CARBIDE COMPOSITES

The Microstructure and Thermal Conductive Behavior of Three-Dimensional Carbon/Carbon Composites with Ultrahigh Thermal Conductivity

Effects of Interphase Thickness and Heat Treatment on Transverse Thermal Diffusivity of 3 D C / SiC Composites

Densification Behavior and Performances of C/C Composites Derived from Various Carbon Matrix Precursors

Preparation and Characterization of Large Diameter Pitchbased Carbon Fiber/abs Resin Composites with High Thermal Conductivities

Thermal Conductivity Enhancement of Carbon Fiber Composites

Mechanical and thermal conduction properties of carbon/carbon composites with different carbon matrix microstructures

The positive role of mesophase-pitch-based carbon fibers in enhancing thermal response behavior in Carbon/Carbon composites

Thermal diffusivity and thermal conductivity of ZrCp/W composites

Mechanical Properties Investigation of Carbon/carbon Composites Fabricated by a Fast Densification Process

Static friction properties of carbon/carbon composites

Research status of thermal conductivity in copper-carbon composite materials

The effective thermal conductivity of coated/uncoated fiber-reinforced composites with different fiber arrangements

Investigation on Thermal Properties of Heat Storage Composites Containing Carbon Fibers

Microstructure and thermal properties of copper matrix composites reinforced by 3D carbon fiber networks