Abstract:Iron catalyst was fabricated via simple solid-state reaction of metal nitrates mixture (Fe, K, Al, Ca, Mg, Sm) with oxalic acid dihydrate at room temperature. Iron catalysts prepared by conventional methods, such as co-precipitation and fusing, are also included as comparison. The performances of catalysts were evaluated by the Fischer-Tropsch Synthesis (FTS) in a fixed bed reactor. The results indicate that uniform nanoparticles were obtained with surface area as high as 38.7 m(2)/g prepared by solid-state reaction. Following calcination at 500 degrees C, gamma-Fe2O3 were obtained as the catalyst precursor. By contrast, alpha-Fe2O3 was the main precursor derived from co-precipitation. In addition, gamma-Fe2O3 prepared by solid-state reaction facilitates the formation of active phase, Fe5C2 with the exposure of (021) facet. High Miller index surface (021) facilitates the adsorption and the dissociation of CO, which contributes the high activity and high selectivity to light olefins. Consequently, compared with conventional catalysts, solid-state reaction derived catalysts exhibit much higher FTO reaction activity and selectivity to lower olefins. The FTY value of 5.62 x 10(-3) mol(CO) g(Fe)(-1) s(-1) was obtained which is almost two times higher than that of catalyst prepared by co-precipitation (3.19 x 10(-3) mol(CO) g(Fe)(-1) s(-1)) or 3 times higher than that of catalyst prepared by fusing method (1.98 x 10(-3) mol(CO) g(Fe)(-1) s(-1)). The selectivity to light olefins of around 40% is obtained which is significantly higher than that of the reference catalysts (25% and 33% respectively). The present study provides a promising pathway to prepare iron based catalysts at room temperature.

STUDY ON THE PREPARATION PRINCIPLE OF IRON OXIDES AND DESULFURIZATION ACTIVITY

Influence of Different Preparation Methods on Crystallisation and Morphology of Fe2o3 Nanoparticles

PREPARATION OF IRON-DOPED TITANIA NANOCRYSTALLINE GRAINS AND ITS PHOTOCATALYTIC PROPERTY

Preparation of α-FeOOH with different crystallinity and its low-temperature desulfurization performance

Preparation of Rodlike Iron Oxide and Its Modification-Ultrasonic Desulfurization Performance

CH4 Oxidation to Oxygenates with N2O over Iron-Containing Y Zeolites: Effect of Preparation

Study on preparation and properties of zinc ferrite and titanium dioxide

The Preparation and Properties of Iron-based Oxygen Carrier Using Sol-Gel Method

Preparation and Catalytic Property of Single Crystal Multiporousα-Fe_2O_3 Nanorods

PREPARATION FOR PYRITE BY SOLVOTHERMAL METHOD

Study on the Preparation and Properties of Colored Iron Oxide Thin Films

Hydrothermal preparation of α-Fe2O3 nano-scale spheres and their photocatalytic property study

Study of intrinsic sulfidation behavior of Fe2O3 for high temperature H2S removal

Heterogeneous Uptake and Oxidation of So2 on Iron Oxides

PREPARATION, CHARACTERIZATION AND CATALYTIC ACTIVITY OF THE SPINEL FERRITES

Experimental study on integrated desulfurization and denitrification of low-temperature flue gas by oxidation method

Solvothermal Synthesis of Monodisperse Iron Oxides with Various Morphologies and Their Applications in Removal of Cr(vi)

Effect of Hydroxylation and Carboxylation on the Catalytic Activity of Fe2O3/Graphene for Oxidative Desulfurization and Denitration

Γ-Fe2o3 As the Precursor of Iron Based Catalyst Prepared by Solid-State Reaction at Room Temperature for Fischer-Tropsch to Olefins

Hydrothermal synthesis and characterization of α-FeOOH and α-Fe2O3 uniform nanocrystallines

Dispersion and Physico-Chemical Characterization of Iron Oxide on Various Supports