Abstract:A study has been made of the electrical behaviour of In-doped metal organic vapour phase epitaxy (MOVPE) layers of Hg(1-x)Cd(x)Te grown by the interdiffused multilayer process (imp) in order to establish the factors needed to obtain uniform extrinsic n-type layers with high electrical activity and mobility. Layers with x between 0.2 and 0.3 were grown on (100) CdTe and CdTeSe at 360-degrees-C using di-isopropyltelluride (DIPT) and doped with trimethylindium (TMIn) in two ways, depending on In concentration, [In]. For [In] > 1 x 10(17) cm-3 layers were doped with TMIn on the CdTe part of the imp cycle while for [In] in the range 1 X 10(15) to l X 10(17) cm-3 the TMIn memory of the growth system was used, resulting in doping on the HgTe part of the imp cycle because of a greater efficiency of incorporation. In profiles, which were determined by secondary-ion mass spectrometry (SIMS), are shown to depend on doping process due to TMIn partial pressure variations from adsorption effects. The layers, which were capped with CdTe to prevent inadvertent post-growth annealing from affecting the electrical activity of the In, were p type when undoped. On doping, as-grown layers become n type at 77 K at [In] approximately 1 x 10(16) cm-3 due to the concentration of donors exceeding the background concentration of Hg acceptor vacancies. The percentage of In electrically active is 33 % at [In] less-than-or-equal-to 2 x 10(18) cm-3 and 15-20 % at higher [In]. The 77 K Hall mobilities of layers, both p and n type, are low when [In] > 1 x 10(16) cm-3, probably because of high levels of compensation. Low temperature annealing to remove Hg vacancies, both ex situ and in situ, significantly improves the electrical properties. Electrical activity of the In increases to 100 % over the [In] range 1 x 10(15) to 2 x 10(18) cm-3 and to 40 % at higher concentrations. 77 K Hall mobility of the n-type layers increases and shows a dependence on carrier concentration and x consistent with lightly compensated material. Results are in agreement with In doping introducing autocompensating centres which anneal out on a low-temperature Hg-rich anneal.

Growth, Structure and Electrical Properties of Mercury Indium Telluride Single Crystals

Growth and Characterization of Mercury Indium Telluride Single Crystals

Synthesis and Crystal Growth of Mercury Indium Telluride

Study on the growth and thermal characteristics of mercury indium telluride crystals

Hg(3-3x)In2xTe3: A Novel Semiconductor Material for Near Infrared Photovoltaic Detectors

Preparation and thermal stability of mercury indium telluride single crystals

Single-crystal Growth of Mercury Indium Telluride (MIT) by Vertical Bridgman Method (VB)

Crystal Growth of Mercury Indium Telluride

High Temperature X-Ray Diffraction Study on Phase Transformation and Lattice Thermal Expansion of Mercury Indium Telluride Crystals

Etch Pits Observation And In Distribution In Mercury Indium Telluride Single Crystals

Preparation and Properties of a Novel Near Infrared Photovoltaic Detector Single-Crystal Material

Defect Characterization And Composition Distributions Of Mercury Indium Telluride Single Crystals

Study of Thermal Expansion of Mercury Indium Telluride Crystals by XRD Technique

Growth and Properties of 40mm Diameter Hg1−xCdxTe Using the Two- Stage Pressurised Bridgman Method

Characterization of Hgmnte Crystals Grown by Vertical Bridgman Method

Optical and Electronic Characterization on HgCdTe Materials

The Growth and Properties of In-Doped Metalorganic Vapor-Phase Epitaxy Interdiffused Multilayer Process (Hgcd)te

Synthesis, crystal growth, electronic structures and optical properties of wide bandgap semiconductor (CH3NH3)2HgI4

Growth of Hg0.7Cd0.3Te on Van Der Waals Mica Substrates via Molecular Beam Epitaxy

Growth, Structure and Optical Properties of Organic–inorganic Hybrid CH3NH3HgI3 Crystal

Control of the Electrical Properties of In-doped HgCdTe Grown by MOVPE for IR Detector Applications