Abstract:The gradual depletion of fossil fuels and increasing environmental pollution problems inspire researchers to seek renewable and clean energy. Lignocellulosic biomass is deemed to be a sustainable and promising resource to produce chemicals and fuels due to its abundant existence in nature. Hydrodeoxygenation (HDO) of phenolic compounds in bio-fuel is a promising technology to convert biomass materials to value-added chemicals and fuels. However, the development of highly efficient catalysts remains a great challenge. In this work, a series of N modified Ni2P-N-x/SiO2 catalysts were prepared by impregnation method. The structure of the catalysts was characterized by X-ray diffraction (XRD), N-2 physical adsorption desorption (BET), H-2 temperature programmed reduction (H-2-TPR), NH3 temperature programmed desorption (NH3-TPD), pyridine infrared (Py-FTIR), transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), and the influence of Ni/N molar ratio on the physicochemical properties of the catalysts was systematically investigated. Using m-cresol as a model compound, the effects of Ni/N molar ratio, reaction temperature, reaction time, and reaction pressure on the HDO performance were studied. It was found that the appropriate introduction of N element can promote the formation of smaller active particles, improve the dispersion of active components, thus enhancing the catalytic activity. The Ni2P-N-1.0/SiO2 catalyst with a Ni/N ratio of 1.0 exhibited the best HDO activity. Under the conditions of 250 degree celsius, 3 MPa, and 1 h, m-cresol conversion reached 93.2%, and the selectivity of the target product methylcyclohexane (MCH) reached 94.2%. Based on the product distribution, it can be inferred HDO of m-cresol over Ni2P-N-x/SiO2 catalyst proceeded mainly via hydrogenation-deoxygenation (HYD) pathway. Furthermore, this series of catalysts also displayed excellent recyclability, m-cresol conversion, as well as the selectivity towards MCH did not decrease obviously even after 5 successive cycles. We believe that this strategy can provide a simple and repeatable route to synthesize high-performance HDO catalysts.

Preparation of p-Hydroxybenzaldehyde by Liquid Phase Catalytic Oxidation of p-Cresol

Study on preparation of p-hydroxybenzaldehyde by p-cresol oxidation

Highly Catalytic Performance for the Selective C-H Bond Oxidation of P-Chlorotoluene over Co, Cr Co-Doped OMS-2 Catalyst

Liquid Phase Catalytic Oxidation of Cumene

Role of Alkali in Catalytic Oxidation of P -Cresols

Review on Synthesis of p-Hydrobenzaldehyde by p-Cresol Catalytic Oxidation

Surface Properties of CoMg/Al2O3 Catalysts Evaluated in Aerobic Oxidation of P-Cresol

Preparation of Co/Cu/γ-Al_2O_3 catalysts and its properties

Catalytic Performance of Ba-Modified Pd/Al2o3 for Liquid Phase in Situ Hydrogenation of Phenol to Cyclohexanone

Catalytic Transfer Hydrogenation of Furfural to Furfuryl Alcohol by Cu-Pd/Al2O3 in Near-Critical Isopropanol

Synthesis of 2-Pyridinealdehyde by Catalytic Oxidation of 2-Methylpyridine in Gaseous Phase

Preparation of 2-t-Butyl-p-cresol Catalyzed by Hβ Zeolite

Cobalt−salen Intercalated Montmorillonite Catalyst for Air Oxidation of p-Cresol under Mild Conditions

Highly Selective Oxidation of Benzyl Alcohol to Benzaldehyde with Hydrogen Peroxide by Biphasic Catalysis

An Efficient and Mild Method for the Alkylation of p-Cresol with tert-Butyl Alcohol

Preparation of Mesoporous Supported CuCo2O4 Catalyst and Selective Oxidation of Benzyl Alcohol

Preparation of Benzaldehyde by Aerobic Liquid-Phase Oxidation of Toluene with Co(acac)2

Process Optimization of Synthesizing p-Methoxybenzyl-alcohol by Catalytic Hydrogenation

Preparation of N Modified Ni2P-Nx/SiO2 Catalysts and Hydrodeoxygenation Performance of M-Cresol

Alkylation of p-cresol with tert-butanol catalyzed by novel multiple-SO3H functioned ionic liquid

Research on in Situ Hydrogenation of O-Cresol over Ni/CMK-3 Catalysts