Abstract:As a promising alternative refrigerant for meeting carbon reduction targets, R32+R1234yf binary mixtures combine the thermal performance of R32 with the environmental performance of R1234yf. Since the degree of heat dissipation during the boiling process is closely related to bubble behavior, the bubble growth and heat transfer characteristics of R32+R1234yf mixtures must be understood in depth. Accordingly, this study proposed a numerical model for single bubble growth during nucleate pool boiling of mixtures. Numerical simulations of single bubble growth in R32, R1234yf, and four binary mixtures thereof were conducted. Owing to the prefer-ential evaporation of the more volatile component, a low concentration region of R32 appeared in the liquid near the heating surface, while the concentration of R32 in the vapor was generally higher than that in the liquid. The evaporation heat flux at the bubble interface in the mixtures was significantly lower than in pure R32, indicating that the existence of mass transfer resistance considerably reduced the heat transfer capacity of mixtures. In contrast to a pure fluid, the microlayer evaporation in a mixture might terminate owing to an increase in the local bubble point temperature, and two modes of microlayer evaporation-called "bubble-point-controlled mode" and "thickness-controlled mode"-were identified accordingly. The total heat transferred during bubble growth first decreased and then increased with an increase in the bulk concentration of R32; a minimum value was observed at an R32 mol fraction of approximately 0.4. This result is consistent with the observed variation in the difference between the vapor and liquid phase concentrations. Overall, this study provides a detailed description of the mass and heat transfer characteristics during single bubble growth in binary mixtures, contributing to a deeper understanding of the associated boiling heat transfer mechanisms.

Photographic Study of Bubble Dynamics for Pool Boiling of Refrigerant R11

Observation and Analysis of the Detachment Frequency of Coalesced Bubbles in Pool Boiling Liquid Nitrogen

A Review of Pool-Boiling Processes Based on Bubble-Dynamics Parameters

Numerical Study on Bubble Departing Behavior from Heated Surface in Subcooled Pool Boiling

Numerical Simulation of Single Bubble Growth and Heat Transfer of R32+R1234yf Binary Mixtures During Saturated Pool Boiling

Simulation of Single Bubble Dynamic Process in Pool Boiling Process under Microgravity Based on Phase Field Method

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Numerical Study on Bubble Behaviour and Heat Transfer Characteristics of Subcooled Pool Boiling Based on Non-Empirical Boiling and Condensation Model

Numerical simulation on subcooled pool boiling bubble behavior

Experimental investigation on the characteristics of bubble growth and slide on a downward-facing heater surface in flow boiling

Visual Study of Flow Pattern Evolution of Flow Boiling in A Microtube

Formation and Growth of R32/R1234yf Nanobubble on Smooth Surface: Molecular Dynamics Simulations

Experimental investigation on bubble dynamics and boiling heat transfer for saturated pool boiling and comparison data with previous works

Numerical Simulation of Nucleate Pool Boiling under High Pressure Using an Initial Micro-Layer Thickness Model

Molecular Dynamics Simulations of R32/R1234yf Nanoscale Boiling on a Smooth Substrate

Experimental Observation On Bubble Dynamics During Nucleate Boiling In Micro/Mini/Macro Tubes

Experiments to compare the dynamics and thermal impact of single vapor bubble subjected to upward and downward flow boiling configurations

Visualization of R410A Flow Boiling Inside Horizontal Smooth Tubes under Diabatic Conditions

Numerical Simulation Research of Bubble Characteristics and Bubble Departure Diameter in Subcooled Flow Boiling

Visualization of A Single Boiling Bubble in A Dc Electric Field

Experimental determination of the role of roughness and wettability on pool-boiling heat transfer of refrigerant