Abstract:For the past few years, research in the field of flow boiling heat transfer has gained immense popularity for unravelling the dominant mechanism responsible for controlling heat transfer and identifying a parametric trend for understanding the characteristics of flow boiling heat transfer. This has led to several assumptions and models for predicting heat transfer during flow boiling without any known generalized mechanism. This study therefore seeks to experimentally study the characteristics of heat transfer during flow boiling over a wide range but small increase in vapor quality from a single-phase subcooled region through to a two-phase superheated vapor region. The study was performed with an R134a refrigerant in a single horizontal circular stainless-steel smooth tube that had an internal diameter of 5 mm. In this experimental study, local heat transfer coefficients and frictional pressure drop were measured for low heat fluxes of 4.6–8.5 kW/m2, mass fluxes of 200–300 kg/(m2s), vapor quality from −0.1 to 1.2 and a low constant saturation pressure of 460 kPa. Flow patterns observed during the study were recorded with a high-speed camera at 2000 fps. In covering a wide range of vapor quality, a peak of heat transfer coefficient near a vapor quality of zero and a local minimum observed in the low vapor quality region were observed, and both were sensitive to heat flux and mildly sensitive to mass flux. Generally, at low vapor quality, the heat transfer coefficient deteriorated with vapor quality and this was sensitive to heat flux but insensitive to mass flux and vapor quality, indicating nucleate boiling dominance in low vapor quality regions. In high vapor quality regions, the heat transfer coefficient was sensitive to mass flux and insensitive to heat flux. This indicates the dominance of convective boiling. In the low vapor quality regions, the flow patterns observed were slug and intermittent, while in the high vapor quality region, annular and mist flow patterns were observed. Generally, frictional pressure drop increased with increasing mass flux and vapor quality in the two-phase region.

Experimental determination of the role of roughness and wettability on pool-boiling heat transfer of refrigerant

Experimental Investigation of Spray Cooling Performance in Non‐boiling Zone on Rough Superhydrophilic/hydrophobic Surfaces

Pressure Drop and Heat Transfer of Flow Boiling R134a in a Dimpled Flat Duct

Subcooled Pool Film Boiling Heat Transfer from Spheres with Superhydrophobic Surfaces: an Experimental Study

Experimental study on the pool boiling heat transfer of R134a outside various enhanced tubes

Study on Flow Boiling Heat Transfer Characteristics of R161/oil Mixture Inside Horizontal Micro-Fin Tube

Regulated Transient Pool Boiling of Water During Quenching on Nanostructured Surfaces with Modified Wettability from Superhydrophilic to Superhydrophobic

Experimental and Analytical Study on the Influence of Saturation Pressure and Surface Roughness on Pool Boiling CHF of HFE-7100

Experimental Study of Horizontal Flow Boiling Heat Transfer Coefficient and Pressure Drop of R134a from Subcooled Liquid Region to Superheated Vapor Region

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Flow Boiling Heat Transfer Characteristic of Refrigerant R1234ze(E) in Horizontal Circular Tube

Study of the Natural Circulation Flow Boiling Heat Transfer Based On Partially Superhydrophilic Surface Modification

Experimental investigation on the flow boiling of R134a in a plate heat exchanger with mini-wavy corrugations

Flow Boiling Heat Transfer of R134a in a Horizontal Smooth Tube: Experimental Results, Flow Patterns, and Assessment of Correlations

Effect of surface roughness on pool boiling heat transfer of water on hydrophobic surfaces

Heat transfer enhancement of helical tubes during pool boiling

Experiment on Boiling Heat Transfer of Refrigerant R134a in Mini-channels

Pool Boiling Heat Transfer of R141b on Surfaces Covered Copper Foam with Circular-Shaped Channels

Experimental study of falling film evaporation of refrigerants, R32, R1234yf, R410A, R452B and R454B on horizontal tubes

Nucleate boiling heat transfer of R-134a and R-134a/POE lubricant mixtures on smooth tube

An experimental study on two-phase flow patterns and heat transfer characteristics during boiling of R134a flowing through a multi-microchannel heat sink