Abstract:The graduator is a very important standard device in the optical angular measuring instrument, which determines the measure precision of the measuring instrument. A new graduator test method is discussed in this paper. This test method is a dual dynamic imaging measurement method with dual digital microscope system, which acquires the images of the graduator rotated by a rotating motor. Here is the introduction of this method with more detail. At first, fix a graduator to be measured on a rotary stage, this stage will be driven by a high precision programmable motor. Make the stage rotate with a constant angular velocity ω. Then place the digital microscope system upon the graduator. The digital microscope system includes two digital microscopes, which placed in the opposite diameter direction. Each digital microscope is made up of optical lens and a CMOS electro-ocular. The sampling frequency f can be set in the control software of the elector-ocular. The two digital microscopes make up a dual dynamic image acquire system. This system can acquire two images of the moving graduator at the same time with the sampling frequency f. Then, a serial of the graduator images can be acquired after a period of rotation, and there is a constant angular difference ω/f between every adjacent image. Each image of the graduator includes several graduation lines, identify these lines and get the position of the lines with image processing method. The measuring value of the rotate angle can be calculated from the adjacent line positions. Use the angular difference ω/f as a standard value of the rotate angle. Compare the measuring value and the standard value with the "comparing method of graduator measurement" formula. A compare result will be given to judge the graduator is good or not at last. The whole system is divided into four functional units: 1,the motion control unit;2,the dual dynamic imaging unit; 3, the image processing unit; 4,the data analysis unit. The measurement principle is introduced in the first part of the paper. In this part, the background of graduator measurement and the theories of graduator measurement are referred. According to the measurement principle a system design is made in the second part of the paper. In this part, the whole measure system is described: the structure of the system, the function of each component and the specifications for the key components. An experiment system is build up under the design, and some measurement data is obtained, the error analyses of the measure data is given at the last of the paper.

Design and test of a constant force generator

A Graduator Test Method Based on Dual Dynamic Image Processing

Design of Force-Balance Capacitive Accelerometer

Six-axis Force/Torque Sensor Based on Stewart Platform

Design and application of a micro-force measuring system based on the principle of torsion balance

Simulation and Modelling of a Precision Method for Static Low Force Measurement

Improved Calibration System of Micro-Cantilever Spring Constant

Design and Experimental Verification of an Adjustable Constant-Force Mechanism

The Device for Calibration Based on the Six-freedom of Generalized Force

Micro-thrust Force Measurement Method Using Series Connected Double Elastic Elements

Calibration of the Effective Spring Constant of Ultra-Short Cantilevers for A High-Speed Atomic Force Microscope

Interactive Control System of Variable Force Feedback Robot Based on Spring Model

Astronuat body mass measurement device calibrated with miniatrue load cell

A measuring method for micro force based on MEMS planar torsional spring

A Novel Flexible Centralized Force Sensor Based on Tri‐Axis Force Refactoring Method for Arbitrary Force Components Measurement

Design and Evaluation of an Adjustable Compliant Constant-Force Microgripper

Development of Static Test Equipment and a System for Lever-Loaded Air Springs

Design and Testing of a Novel Nested, Compliant, Constant-Force Mechanism with Millimeter-Scale Strokes

Electrometric Method for Measuring the Mechanical Parameters of a Comb-Finger Micro-Mechanical Accelerometer

Comparison and Analysis of Different Methods in Calibration of the Spring Constant of AFM Cantilever Probes

Analysis and Optimization on Dynamic Characteristics and Important Parameters of Force Feedback Accelerometer