Abstract:This paper presents a generic-purpose solution of highly power-efficient active-RC filters, which is suitable for analog baseband with wide bandwidth-range from several mega-Hz to hundreds of mega-Hz in wireless receivers. A 260 μA 7-20 MHz 6th-order active-RC low-bandwidth low-pass filter (LBW-LPF) and a 2.3 mA 240-500 MHz 6th-order active-RC high-bandwidth low-pass filter (HBW-LPF) are implemented in a standard 0.18 μm CMOS process to demonstrate this versatile solution. Highly power-efficient push-pull opamps with 30-to-35 dB gain are adopted for the filters, which allow us to focus on extending the bandwidth and reducing the power consumption. The push-pull opamp with adaptive-biased and pole-cancellation push-pull source follower (APP-SF) as the buffer stage is proposed to greatly reduce the power consumption and effectively extend the bandwidth. An adaptive bias mechanism is also proposed to tolerate the PVT variations for the opamps. In addition, the GBW compensation and the Q-degrading scheme are adopted to relax the opamp GBW requirement, further reducing the power dissipation. The LBW-LPF only consumes 260 μA current from 1.8 V supply, achieves 14.4 dBm in-band IIP3 and 66.2 nV/√ Hz IRN density, and occupies 0.21 mm 2 silicon area without pads. The HBW-LPF merely dissipates 2.3 mA current from 1.8 V supply, achieves 11.3 dBm in-band IIP3 and 13.1 nV/√ Hz IRN density, and occupies 0.23 mm 2 silicon area without pads.

A 0.47mw 6(Th)-Order 20mhz Active Filter Using Highly Power-Efficient Opamp

A 2.3mA 240-to-500MHz 6th-order active-RC low-pass filter for ultra-wideband transceiver

Highly Power-Efficient Active-RC Filters with Wide Bandwidth-Range Using Low-Gain Push-Pull Opamps

A 5th order 0.8/2.4 GHz programmable active band pass filter for power DAC applications

A CMOS 1.3-1.7GHz Q-Enhanced LC Band-pass RF Filter with 1.5-67% Tunable Fractional Bandwidth

A 0.65mw 20mhz 5Th-Order Low-Pass Filter With+28.8dbm Iip3 Using Source Follower Coupling

A 5.7mw +30dbm IIP3, Tunable Active-RC LPF in 40nm CMOS

Scalable, Low-power and High-performance Active-RC Complex Band-Pass/Low-Pass Filter with Automatic Frequency Tuning Applied to the Internet of Things

0.013 mm2, kHz-to-GHz-bandwidth, thirdorder all-pole lowpass filter with 0.52-to- 1.11 pW/pole/Hz efficiency

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

A 5.4-Mw 50-Mhz 29.3-Dbm-iip3 Fourth-Order Low-Pass Filter

A Highly Linear 0.9V 3Rd-Order Acitve-RC Low-Pass Filter in CMOS 28Nm

A 65 nm 75 MHz–260 MHz sixth-order Active-RC bandpass filter

A 0.6-V Power-Efficient Active-RC Analog Low-Pass Filter With Cutoff Frequency Selection

A High Linearity Active-Rc Bpf With 70mhz Center Frequency And 22mhz Bandwidth In 65nm Cmos

A wide tuning range Active-RC filter for multi-mode applications

A 77-dB-DR 0.65-mW 20-MHz 5th-Order Coupled Source Followers Based Low-Pass Filter

A 0.6mw 31mhz 4Th-Order Low-Pass Filter with +29dbm IIP3 Using Self-Coupled Source Follower Based Biquads in 0.18µm CMOS

A single-branch third-order pole-zero low-pass filter with 0.014-mm 2 die size and 0.8-kHz (1.25-nW) to 0.94-GHz (3.99-mW) bandwidth-power scalability

Cost-Efficient Cmos Rf Tunable Bandpass Filter With Active Inductor-Less Biquads

A 6Th-Order Chebyshev Active-Rc Complex Filter Employing Feedforward Compensation Operational Transconductance Amplifiers Achieving+39.1dbm Iip3