Abstract:Increasing demands for high-performance screw pumps in oil and gas as well as other applications require deep understanding of the fluid flow field inside the machine. Important effects on the performance such as dynamic losses, influence of the leakage gaps and presence and extent of cavitation are difficult to observe by experiments. However, it is possible to study such effects using well-validated computational fluid dynamics models. The novel-structured numerical mesh consisting of a single-computational domain for moving screw pump rotors was developed to allow three-dimensional computational fluid dynamics simulation of such machine possible. Based on finite volume method, the instantaneous mass flow rates, rotor torque, local pressure field, velocity field and other performance indicators including the indicated power were predicted. A calculation model for the bearing friction losses was introduced to account for mechanical losses. The geometry of the inlet and outlet passages and piping system are taken into consideration to evaluate their influences on the pressure distribution and shaft power. The paper also shows the influence of rotor clearances on the pump performance. The computational fluid dynamics model was validated by comparing the numerical results with the measured performance obtained in the experimental test rig through the comprehensive experiment performed for a set of discharge pressures and rotational speeds. Validation includes comparison of mass flow rates, shaft power and efficiency under variety of speeds and discharge pressure. It has been found that the predicted results match well with the measurements. The results also showed that the radial clearances have larger influence on the mass flow rate than the interlobe clearance. The correct design of the flow passages within the screw pump plays significant role in minimizing required power consumption. The analysis presented in this paper contributes to better understanding of the working process inside the screw pump and offers a good reference to improve design and optimize such machines in terms of clearance selection, shape of the ports, piping system, etc. In future, this model will be used for analysis of cavitating flows and determining performance of other multiphase screw pumps.

Theoretical Analysis on Leakage Model of Twin-screw Multiphase Pumps

Analysis of force and leakage in water hydraulic motor' s piston pairs

Leakage Model of Distributing Mechanism in Fuel Piston Pump

Analysis of the leakage in a water-lubricated twin-screw air compressor

Modeling and analyzing on pressure distribution of plane port pair based on disk-shape gap

Numerical Simulation on Internal Flow in the Screw Centrifugal Pulp Pump

A practical approach for analysis of leakage flow characteristics in hydraulic pumps

Analysis of axial leakage in high pressure involute internal gear pump

Numerical modelling of twin-screw pumps based on computational fluid dynamics

A centrifugal force interaction analysis on the piston/cylinder interface leakage of bent-axis type piston pumps

A Non-Ideal Geometry Based Prediction Approach of Fitting Performance and Leakage Characteristic of Precision Couplings.

Experimental and Numerical Investigation on the Tip Leakage Vortex Cavitation in an Axial Flow Pump with Different Tip Clearances

Analysis of Leakage Flow and Dynamic Characteristics in Floating Ring Seals for High Pressure Turbopump

Internal clearance flow and leakage loss in multi-stage centrifugal pump

An experimental technique to simulate and measure leakages in twin-screw compressor

Low Leakage and High Volumetric Efficiency Research of Seawater Plunger Pump

Investigation of flow field characteristics in hose pumps under various operating conditions and their impact on gap leakage

Tip Leakage Vortex Trajectory and Dynamics in a Multiphase Pump at Off-Design Condition

Performance analysis of embedded tri-screw pump based on computational fluid dynamics

Theoretical study on leakage characteristics of water-injected single screw vapor compressors with a multicolumn envelope meshing pair

Theoretical Prediction Model of Tip Leakage Vortex in a Mixed Flow Pump With Tip Clearance