Abstract:Accurate prediction of welding residual stresses is often challenging due to the complexity of the welding process which includes moving heat source, temperature-dependent material properties etc. Over the past two decades or so, the numerical simulation technologies have been widely used in the welding process and a number of numerical models have been proposed to predict temperature field and residual stresses field induce by welding process. In the previous numerical simulations, the weldment was either in Free State or rigidly constrained. Such manipulations can not reflect the realistic constraint conditions of the weldment. In this simulation, clamps and backing board are all included in the model as elastic body and analytical rigid body, respectively. In the thermal analysis, the thermolysis of clamps and backing board can be equivalent to forced convection heat transfer, where the coefficients of forced convection heat transfer are temperature dependent; in the mechanical analysis, both the contact interaction between clamps and weldment and the contact interaction between backing board and weldment are considered, normal and tangent contact interaction properties are assumed as "HARD" contact and Coulomb friction, respectively. After welding process, residual compressive plastic strains existing in the weld zone and HAZ are the sources of residual stresses. Post welding cold rolling is an effective and convenient method to reduce residual compressive plastic strains induces by welding especially for thin-walled structure. In the previous researches, either welding process and cold rolling process were treated as two separate processes or only the residual stresses induced by welding process was considered as initial condition in the cold rolling process. In this simulation, welding residual stresses, plastic strains and deformations are all imported as the initial state of the cold rolling process to increase the accuracy of the numerical simulation. The import of plastic strains will affect the accuracy of the numerical simulation for the material which has obvious work harden effect.

Application analysis of numerical simulation in welding

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Development Status of Welding Numerical Simulation Technology

Finite element simulation of welding process and real-time monitoring assessment

Present Situation and Prospect of Welding Simulation Technology

Precision and Efficiency Sensitivity of Some Key Techniques in Thermo-mechanical Numerical Simulation of Welding Process

Numerical Analysis of Welding in Fillet Weld for High-Pressure Pipeline In-Service

Sensitivity Analysis of Some High Efficiency Computational Methods for Welding Process Numerical Simulation

Numerical Simulation of Arc Welding

Numerical Simulation of Tube-Plate Welding Structure with T-Shaped Sections

Numerical simulation and analysis of welding of drive axle housing and axle tube

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

A review of welding simulation methods for large components

Simulation of three-dimensional temperature field in high-frequency welding based on nonlinear finite element method

Current status of research on numerical simulation of droplet transfer in CO2 gas–shielded welding

Application of the stochastic finite element method in welding simulation

High precision modeling of welding and post welding cold rolling continuous process in numerical simulation

Three Dimensional Numerical Simulation of Temperature and Stress Distribution in Welding of Thick Plate

A complementary approach to experimental modeling and analysis of welding processes: dimensional analysis

Numerical Simulation of Welding for Residual Stress Prediction of Low Carbon Steel

Finite element synthesized analysis of the forming process of spiral welded pipe