Abstract:The oxygen/silver system exhibits unique catalytic behavior for several large-scale oxidation (and partial oxidation) industrial processes. In spite of its importance, very little is known on the microscopic level concerning the atomic geometry and chemical nature of the various O species that form. Using density-functional theory within the generalized gradient approximation, the interaction between atomic oxygen and the Ag(111) surface is investigated. We consider. for a wide range of coverages. on-surface adsorption as well as surface-substitutional adsorption. The on-surface fcc-hollow site is energetically preferred for the whole coverage range considered. A significant repulsive interaction between adatoms is identified, and on-surface adsorption becomes energetically unstable for coverages greater than about 0.5 monolayer (ML) with respect to gas-phase O-2 The notable repulsion even at these lower coverages causes O to adsorb in subsurface sites for coverages greater than about 0.25 ML. The O-Ag interaction results in the formation of bonding and antibonding states between Ag 4d and O 2p orbitals where the antibonding states are largely occupied, explaining the found relatively weak adsorption energy. Surface-substitutional adsorption initially exhibits a repulsive interaction between O atoms, but for higher coverages switches to attractive, towards a (root3 x root3)R30degrees structure. Scanning tunneling microscopy simulations for this latter structure show good agreement with those obtained from experiment after high-temperature and high-O-2-gas-pressure treatments. We also discuss the effect of strain and the found marked dependence of the adsorption energy on it, which is different for different kinds of sites.

Oxygen Adsorption on Zr(0001) Surfaces : Density Functional Calculations and a Multiple-Layer Adsorption Model

Initial Subsurface Incorporation of Oxygen into Ru(0001): A Density Functional Theory Study

Initial Subsurface Incorporation of Oxygen into Ru(0001): A Density Functional Theory Study.

A Density-Functional Theory Study on the Chemisorption and Stm Images of Ag(100)/O Surface

THEORETICAL STUDY OF THE ADSORPTION AND DIFFUSION OF OXYGEN ATOM ONO-TERMINATEDZnO$(000\bar 1)$ SURFACE

Adsorption of oxygen atom on Zn-terminated (0001) surface of wurtzite ZnO: A density-functional theory investigation

The Atomic Structure and Electronic States of Oxygen- Adsorbed on Cu(110)c(2×1) Surface

Density Functional Theory Study on the Atomic Structure and Electronic States of Cu(100) (2×22)R45°-O Surface

Oxygen Adsorption on Ag(111): A Density-Functional Theory Investigation

Density-Functional Theory Investigation of Atomic Geometry and Oxygen Adsorption of Au(110) Surface

Density functional theory study on the atomic structure and electronic states of Cu(l00) (√2 × 2 √2)R45°-O surface

Atomic oxygen adsorption and incipient oxidation of the Pb(111) surface: A density-functional theory study

First-principles modeling of oxygen interaction with SrTiO3(001) surface: Comparative density-functional LCAO and plane-wave study

Influence of Oxygen Partial Pressure on the Adsorption and Diffusion During Oxide Growth: Zno(0001) Surface

Sub-surface Oxygen and Surface Oxide Formation at Ag(111): A Density-functional Theory Investigation

Structure of Reconstructed Cu(100) Surface Induced by Dissociative Adsorption of Gaseous Oxygen

Ab-initio density functional study of O on the Ag(001) surface

Enhanced performance of oxygen vacancies on CO2 adsorption and activation over different phases of ZrO2

First-principles study of the polar O-terminated ZnO surface in thermodynamic equilibrium with oxygen and hydrogen

Oxygen Adsorption on Ag∕Si(111)-7×7 Surfaces

Adsorption of Ag and Au Atoms on Wurtzite ZnO (0001) Surface