Abstract:The self-sustained flapping of a three-dimensional flexible plate in a uniform viscous flow is numerically simulated with a fictitious domain method. The effects of the various non-dimensional control parameters including the Reynolds number, the density ratio, the dimensionless shear modulus, the length–thickness ratio, and the width–length ratio on the flapping of the plate are investigated. The results show that there exist two flapping modes: symmetrical and asymmetrical flapping about the centerline in the spanwise direction. Near the critical point a decrease in the plate width–length ratio, or the increase in the Reynolds number or the reduced velocity (a combination of the density ratio, the dimensionless shear modulus, and the length–thickness ratio) can make symmetric (or nearly symmetric) flapping become asymmetric. It is found that the flapping amplitude is mainly controlled by the density ratio and the dimensionless elastic modulus, while the frequency by the density ratio and the length–thickness ratio. In addition, the flapping amplitude and frequency are affected significantly by the confinement effect of the computational domain, and normally enhanced as the confinement effect becomes stronger. The effects of the plate width and the mass ratio (i.e., the ratio of the length–thickness and density ratios) on the critical reduced velocities are examined. The results indicate that when the fluid–plate mass ratio (or the plate length–thickness ratio) is relatively small there exist two significantly different critical velocities for the flapping instability, depending on the strength of initial plate deformation, a hysteresis phenomenon. No obvious hysteresis can be observed when the fluid–plate mass ratio (or the plate length–thickness ratio) is large.

The Effect of Plate Temperature on the Onset of Wetting

The Thermal and Pasternak Foundation Effect on the Transient Behaviors of the Rectangular Plate Using a Novel Semi-Analytical Method

Temperature Dependence of the Contact Angle of Water on a Hydrophobic Surface at Pressurized Condition

On the Wetting Mechanism of Liquid Flow on Hot Surfaces

Numerical Investigation on Wetting Behavior and Heat Transfer Characteristics of Film Flow on the Smooth and Orthogonal Wave Plates

The Effect of Energy Accumulation and Boundary Slip on Laminar Flow Between Rotating Plates

Effect of evaporation rate for the heat and mass transfer of the laminar liquid falling film in still air

Capillary-induced Rewetting in a Flat Porous Cove Layer

An Investigation of Falling Liquid Films on A Vertical Heated/Cooled Plate

Study on Film Boiling Heat Transfer for Water Jet Impinging on High Temperature Flat Plate

Numerical simulations of the flapping of a three-dimensional flexible plate in uniform flow

Non-isothermal wetting during impact of millimeter size water drop on a flat substrate: numerical investigation and comparison with high-speed visualization experiments

Transient free convection about a vertical flat plate embedded in a porous medium

Instability of Liquid Film Flowing Down A Linearly Heated Plate

Effects of Non-Darcian and Inlet Conditions on the Forced Convection Along a Vertical Plate With Film Evaporation

Numerical Study of the Forced Convective Condensation on a Short Vertical Plate

Deposition of Aerosol Particles in Laminar Flow over a Vertical Plate with Variable Temperatures

Heat Transfer of Laminar Flow over a Plate Embedded in Porous Medium with a Constant Heat Flux under Local Non-Equilibrium Condition

Droplet impact on a heated porous plate above the Leidenfrost temperature: A lattice Boltzmann study

The Influence of Temperature on Anisotropic Wettability Revealed by Friction Force Measurement

Film deposition and transition on a partially wetting plate in dip coating – CORRIGENDUM