Abstract:Researches of flow and dispersion in urban area are important to meet the practical demands of studies of vehicular exhaust pollution and accidental leakage. Numerical simulations with field observations and physical simulations (e.g., wind tunnel simulation) are often used to address atmospheric flow and dispersion problems in cities. In general, numerical simulations can provide specific detailed informations of flow, turbulence and dispersion. To deal with small-scaled flow and dispersion, computational fluid dynamics (CFD) models are widely applied and are capable of reproducing small-scaled characteristics of flow and dispersion. A CFD model-FLUENT was adopted to simulate the disturbance of a single building on atmospheric flow under the neutral stability condition. Wind tunnel data published by Hamburg University was collected to validate the modeled results and assess the choices of parameters and parameterization schemes. This technique was applied to address atmospheric dispersion problems in quasi-urban building arrays. Concentration data of MUST and a tracer experiment were used to evaluate the dispersion modeling. The results indicated that FLUENT well performed in mean flow simulation under construction disturbance condition. Simulated results for FAC2 of horizontal and vertical modeling wind speed were 77.9% and 61.0% respectively. However, thre was a relatively larger discrepancy between the modeling and measured turbulence characteristics, when the FAC2 of modeling turbulent kinetic energy was 54.6%. The turbulent closure scheme options (i.e., standard K-ε scheme, Re-normalization Group K-ε scheme and Reynolds Stress Model scheme) had trivial effects on simulated results. The dispersion simulation case within quasi-urban buildings was satisfactory. The result of the dispersion case correctly reproduced the irregular plume shifting caused by building disturbance compared to the average wind direction. The modeling concentrations were generally in accordance with measured results, and the relative tolerance of the modeling maximum concentration in lateral profile at 32 and 63 m downwind were 72.5% and 36.9% respectively. Relative to the Gaussian plume model-ISC3, FLUENT can provide more practical concentration distribution under complex conditions. FLUENT simulation also indicated that the maximum lateral concentration decreased along the downwind direction in "step change" pattern between the adjacent street canyons near the release source. The maximum lateral pollutant concentrations in the same street canyon as the source were several times or even one order of magnitude higher than that in the next canyon. FLUENT results can reproduce the phenomena of dispersion towards upwind area and also of accumulation and detouring flow around the constructions. Further researches are required to analyze the phenomena.

Numerical Simulation of Cooling Tower Influences on Atmospheric Dispersion

A Comprehensive High Reynolds Number Effects Simulation Method for Wind Pressures on Cooling Tower Models

Numerical study on interference effects of wind loads about a cluster of tall buildings

Computational fluid dynamics numerical simulation of flue gas emission from stack and tower integration system of coal-fired power plant

Numerical Analysis and Simulation of Characteristics of Atmospheric Diffusion in Coastal Area of Zhangzhou, Fujian

CFD Simulations of Flow and Dispersion under Construction Disturbance Conditions

Numerical simulation of wind load on cooling towers under double-tower condition

Numerical simulation of deposition of drifts and salt from multiple super-large seawater cooling towers

An open GIS based 3D simulation software to predict cooling tower drift diffusion

Simulations of near-source wind development and pollution dispersion over complex terrain under different thermal conditions

High-Resolution Simulation of the Near-Field Pollutant Dispersion in a Nuclear Power Plant Community with High-Performance Computing

Construction and Validation of an Urban Area Flow and Dispersion Model on Building Scales

Numerical Simulation of the Flow Field and Pollutant Dispersion around a Hill under Different Thermal Stratifications

Numerical Study on Water Distribution of Natural Draft Wet Cooling Towers under Crosswind

Numerical Simulation of Fluid Flow and Thermal Performance of a Dry-Cooling Tower under Cross Wind Condition

Three-dimensional Numerical Study on Thermal Performance of a Super Large Natural Draft Cooling Tower of 220m Height

Atmospheric Dispersion Simulation in Low Wind Conditions in Inland Hills and Valleys

Numerical Simulation of Thermal Performance of Indirect Dry Cooling Tower Under Different Operation Modes of Sectors

Lagrangian stochastic simulation of atmospheric dispersion from sources near the ground

Numerical Study of Natural Draft Wet Cooling Tower

Three-dimensional Numerical Study on Water-Distribution Optimization in a Natural Draft Wet Cooling Tower