Abstract:Efficacious regulation of the geometric and electronic structures of carbon nanomaterials via the introduction of defects and their synergy is essential to achieving good electrochemical performance. However, the guidelines for designing hybrid materials with advantageous structures and the fundamental understanding of their electrocatalytic mechanisms remain unclear. Herein, superfine Pt and PtCu nanoparticles supported by novel S,N-co-doped multi-walled CNT (MWCNTs) were prepared through the innovative pyrolysis of a poly(3,4-ethylenedioxythiophene)/polyaniline copolymer as a source of S and N. The uniform wrapping of the copolymer around the MWCNTs provides a high density of evenly distributed defects on the surface after the pyrolysis treatment, facilitating the uniform distribution of ultrafine Pt and PtCu nanoparticles. Remarkably, the Pt1Cu2/SN-MWCNTs show an obviously larger electroactive surface area and higher mass activity, stability, and CO poisoning resistance in methanol oxidation compared to Pt/SN-MWCNTs, Pt/S-MWCNTs, Pt/N-MWCNTs, and commercial Pt/C. Density functional theory studies confirm that the co-doping of S and N considerably deforms the CNTs and polarizes the adjacent C atoms. Consequently, both the adsorption of Pt1Cu2 onto the SN-MWCNTs and the subsequent adsorption of methanol are enhanced; in addition, the catalytic activity of Pt1Cu2/SN-MWCNTs for methanol oxidation is thermodynamically and kinetically more favorable than that of its CNT and N-CNT counterparts. This work provides a novel method to fabricate high-performance fuel cell electrocatalysts with highly dispersed and stable Pt-based nanoparticles on a carbon substrate.A conductive copolymer pyrolysis strategy is developed for preparing S,N co-doped carbon nanotubes, which can effectively improve the dispersion of PtCu nanocrystals and the subsequent methanol electrocatalytic oxidation.

Cu<sub>2</sub>O/MWCNTs Prepared by Spontaneous Redox: Growth Mechanism and Superior Catalytic Activity

Facile synthesis of Fe3O4/MWCNTs by spontaneous redox and their catalytic performance

Remarkable Synergy Effect of Cu–Nb Oxide Nanorods Toward Electrocatalytic Nitrogen Reduction: the Enhanced Mass and Electron Transfer

Manipulating Cu Nanoparticle Surface Oxidation States Tunes Catalytic Selectivity Toward CH4 or C2+ Products in CO2 Electroreduction

A Novel Route of Enhancing Oxidative Catalytic Activity: Hydroxylation of MWCNTs Induced by Sectional Defects

Mn3O4-NiO-Ni/CNTs Catalysts Prepared by Spontaneous Redox at High Temperature and Their Superior Catalytic Performance in Selective Oxidation of Benzyl Alcohol

Copper Vanadate Nanowires on G-C3n4 Toward Highly Selective Oxidation of Methanol to Dimethoxymethane

Facile Synthesis of PtCu3alloy Hexapods and Hollow Nanoframes As Highly Active Electrocatalysts for Methanol Oxidation

Enhancing the Low-Temperature CO Oxidation over CuO-Based -MnO<sub>2</sub> Nanowire Catalysts

In-situ preparation of carbon nanotubes on CuO nanowire via chemical vapor deposition and their growth mechanism investigation

In Situ Analysis of Growth Behaviors of Cu2O Nanocubes in Liquid Cell Transmission Electron Microscopy

New strategy of S,N co-doping of conductive-copolymer-derived carbon nanotubes to effectively improve the dispersion of PtCu nanocrystals for boosting the electrocatalytic oxidation of methanol

Cu2O nanocubes with mixed oxidation-state facets for (photo)catalytic hydrogenation of carbon dioxide

Facile Microwave Synthesis of Hierarchical Porous Copper Oxide and Its Catalytic Activity and Kinetics for Carbon Monoxide Oxidation

Tuning lattice defects to facilitate the catalytic performance of Ni–Cu–O hybrid nanoparticles towards methane oxidation

MOF-Derived Cu@Cu2O Nanocatalyst for Oxygen Reduction Reaction and Cycloaddition Reaction

Copper Nanoflower Assembled by Sub-2 Nm Rough Nanowires for Efficient Oxygen Reduction Reaction: High Stability and Poison Resistance and Density Functional Calculations.

Two-dimensional Porous Cu-CuO Nanosheets: Integration of Heterojunction and Morphology Engineering to Achieve High-Effective and Stable Reduction of the Aromatic Nitro-Compounds

In-situ fabrication of Cu-Mn-O nanostructure catalysts on Ti mesh and their catalytic property optimization for low-temperature and stable CO oxidation

The Promotional Effect of Copper in Catalytic Oxidation by Cu-Doped α-MnO2 Nanorods

Facile Synthesis of Au Embedded CuOx-CeO2 Core/shell Nanospheres As Highly Reactive and Sinter-Resistant Catalysts for Catalytic Hydrogenation of P-Nitrophenol