Abstract:Fe and Cr-doped, Fe-Cr co-doped, and pure TiO 2 nanotubes have been fabricated by single-step titanium anodization. Morphology, crystal structure, elemental composition, and the photoelectrochemical characteristics of the synthesized photoanodes have been investigated by various methods. The photoelectrochemical activity of TiO 2 nanotubes has been improved by doping, and co-doping under Xe light compared with the undoped TiO 2 nanotube irradiation. The results indicated that the performance of the prepared samples was significantly improved under the same conditions compared with the undoped nanotubes. The best co-doped TiO 2 sample (Fe 40 Cr 60 ), prepared by the anodization of titanium in dimethyl sulfoxide (DMSO) solvent including 7.2 mM potassium chromate and 4.8 mM potassium ferricyanide as the chromium and iron sources, respectively, demonstrated photocurrent density of over 200 μA/Cm 2 , which is four times superior to that of the pure TiO 2 nanotube. This study presents a novel approach to improve the photoelectrochemical properties of TiO 2 nanotubes through (Fe-Cr) co-doping using a one-step electrochemical anodization method. Furthermore, the synergistic effect between Fe and Cr significantly enhances the photoactivity of the TiO 2 nanotubes, resulting in improved charge separation efficiency and photocurrent density compared to pure TiO 2 nanotubes. The ability to capture visible light and the photoelectrochemical performance of the co-doped nanotubes were shown to improve under illumination by visible light.

Fabrication of multi-non-metal-doped TiO2 nanotubes by anodization in mixed acid electrolyte

Facile Fabrication of N-doped TiO2 Nanocatalyst with Superior Performance under Visible Light Irradiation

Fabrication of Well-Aligned Tio2 Nanotube Arrays with Outstanding Light-Induced Hydrophilicity Performance

In-situ fabrication of CNT/TiO 2 interpenetrating network film on nickel substrate by chemical vapour deposition and application in photoassisted water electrolysis

Fabrication and formation mechanism of self-organized TiO2 nanotube arrays

Facile Preparation Carbon-Doped TiO2 Nanotube Electrodes and Its Enhanced Photoelectrochemical Response

Fabrication of Titanium Oxide Nanotube Arrays by Anodic Oxidation

Fabrication of multi-sectional TiO 2 nanotube arrays by anodization

Fabrication of Fe<SUB>2</SUB>O<SUB>3</SUB>/TiO<SUB>2</SUB> Nanotube Electrode and Its Photoelectrocatalytic Performance in Dye Wastewater Degradation

Preparation of Iron and Chromium Co-Doped TiO2 Nanotubes and Study of Their Photoelectrochemical Properties

Nanostructured Carbon-Doping Anodic Tio2 From Tic And Its Photoelectrochemical Properties

Preparation of High Efficient Photoelectrode of N–F-codoped TiO2 Nanotubes

Construction of Self-Supported TiO2 Nanotube Arrays with Hybrid Point Defect Engineering: A Bifunctional Anode for Li+/Na+ Storage

Anodization Fabrication of Highly Ordered Tio2 Nanotubes

Anodically grown Si–W codoped TiO 2 nanotubes and its enhanced visible light photoelectrochemical response

Synthesis of TiO<sub>2</sub> Nanotube Arrays Through Multistep Anodization

Facile Synthesis of Ni-doped TiO2ultrathin Nanobelt Arrays with Enhanced Photocatalytic Performance

Fabrication of open-ended TiO2 nanotube arrays by anodizing a thermally evaporated Ti/Au bilayer film

Fabrication of TiO2 Nanotube by Electrochemical Anodization: Toward Photocatalytic Application

Fabrication and Photoelectrochemical Properties of CuO/TiO2 Heterojunction Nanotubes Array Film

F–B-codoping of anodized TiO2 nanotubes using chemical vapor deposition