Abstract:There is a need for developing an accurate and simple method, which can be widely used in agro-hydrological models. The Integrated Richards Equation method is a good and simple method to simulate cyclic movement of water in the soilatmosphere system. However, this method still has some unsolved problems and it is needed for further development if used in agro-hydrological simulation. In this study, the Integrated Richards Equation method was further developed for the agro-hydrological simulation by introducing the commonly used soil hydraulic functions, top and lower boundary conditions. Infiltration numerical experiments and a lab evaporation experiment were used for the validation of the model's capabilities of modelling infiltration and evaporation, respectively. A field evaporation experiment, which was conducted from 27 April to 21 November in 1971, at Big Ground field, Wellesbourne, UK, was used for in-site validation. Soil samples from four replicate plots were taken at 5 cm increments to a depth of 45 cm at regular intervals throughout the experiment. In total, 10 measurements of soil water content down the profile for ten different times were taken during the experiment. Numerical infiltration experiments showed that the proposed method could give good predictions for two contrasting soils, loamy sand and clay loam, under unsteady intense rainfall conditions. The results were in line with those from the complex numerical scheme of FEM. Good results were also obtained in testing the method for evaporation from coarse sand, but the method under-predicted the amount of evaporation from fine sand. The results of testing against data from the field experiment show that the predicted soil water content was in good agreement with the measured values down the soil profile, but not for the soil close to the surface. This indicates that the proposed method performed well in agro-hydrological simulations on agricultural bare soils under different complex conditions at the upper boundary. Thus the method could be applied in agro-hydrological simulations.

A two-dimensional Richards equation solver based on CVODE for variably saturated soil water movement

Extending the Integrated Richards Equation Method to New Boundary Conditions: Model Description and Validation

An Easily Implemented Agro-Hydrological Procedure with Dynamic Root Simulation for Water Transfer in the Crop–soil System: Validation and Application

Simulation of Dynamic Root Growth and Water Transfer in Soil-Crop-atmosphere System

Prediction of Changes in Soil Moisture Due to Rainfall, Infiltration, and Evapotranspiration Using a Physically-Based Model

Modeling Soil Moisture Responses under Evaporative Conditions

Coupled Finite-Volume Model for 2D Surface and 3D Subsurface Flows

Integrated Two-Dimensional Surface and Three-Dimensional Subsurface Contaminant Transport Model Considering Soil Erosion and Sorption

Simulation of Rainfall-Runoff in the Deep Hollow Lake Watershed Using an Integrated Surface-Subsurface Flow Model

A Physically-Based Integrated Numerical Model for Flow, Upland Erosion, and Contaminant Transport in Surface-Subsurface Systems

Subsurface flow model for estimating 2D wetting pattern in drip irrigation

Numerical Model of Richard's Equation Based on an Ordinary Differential Equation Solver

A two-layer numerical model of soil moisture dynamics: Model development

Physically based hydrological model using finite volume methods based on a triangulated irregular network

Empirical Equation for Development of Soil Wetted Body under Surface Drip Irrigation Condition

Numerical scheme for solving the Richard’s equation based on finite volume model with unstructured mesh and implicit dual-time stepping

2d Well-Balanced Positivity Preserving Shallow Flow Model With Wetting And Drying On Triangular Grids

Integrated numerical model for irrigated area water resources management

Approximate solution of a one-dimensional soil water infiltration equation based on the Brooks-Corey model

A Two-Dimensional Numerical Model Coupled with Multiple Hillslope Hydrodynamic Processes and Its Application to Subsurface Flow Simulation

Integration application of finite difference flow modeling and SWAT model in the distribution and transformation of water resources in irrigation areas