Abstract:There is a need for developing an accurate and simple method, which can be widely used in agro-hydrological models. The Integrated Richards Equation method is a good and simple method to simulate cyclic movement of water in the soilatmosphere system. However, this method still has some unsolved problems and it is needed for further development if used in agro-hydrological simulation. In this study, the Integrated Richards Equation method was further developed for the agro-hydrological simulation by introducing the commonly used soil hydraulic functions, top and lower boundary conditions. Infiltration numerical experiments and a lab evaporation experiment were used for the validation of the model's capabilities of modelling infiltration and evaporation, respectively. A field evaporation experiment, which was conducted from 27 April to 21 November in 1971, at Big Ground field, Wellesbourne, UK, was used for in-site validation. Soil samples from four replicate plots were taken at 5 cm increments to a depth of 45 cm at regular intervals throughout the experiment. In total, 10 measurements of soil water content down the profile for ten different times were taken during the experiment. Numerical infiltration experiments showed that the proposed method could give good predictions for two contrasting soils, loamy sand and clay loam, under unsteady intense rainfall conditions. The results were in line with those from the complex numerical scheme of FEM. Good results were also obtained in testing the method for evaporation from coarse sand, but the method under-predicted the amount of evaporation from fine sand. The results of testing against data from the field experiment show that the predicted soil water content was in good agreement with the measured values down the soil profile, but not for the soil close to the surface. This indicates that the proposed method performed well in agro-hydrological simulations on agricultural bare soils under different complex conditions at the upper boundary. Thus the method could be applied in agro-hydrological simulations.

Integrated Two-Dimensional Surface and Three-Dimensional Subsurface Contaminant Transport Model Considering Soil Erosion and Sorption

A Physically-Based Integrated Numerical Model for Flow, Upland Erosion, and Contaminant Transport in Surface-Subsurface Systems

Simulation of Soil Erosion and Sediment Transport Using a Physically-Based Integrated Surface-Subsurface Model

Coupled Finite-Volume Model for 2D Surface and 3D Subsurface Flows

Modeling Pollutant Transport in Overland Flow over Non-Planar and Non-Homogenous Infiltrating Surfaces

Simulation of Rainfall-Runoff in the Deep Hollow Lake Watershed Using an Integrated Surface-Subsurface Flow Model

Extending the Integrated Richards Equation Method to New Boundary Conditions: Model Description and Validation

An Easily Implemented Agro-Hydrological Procedure with Dynamic Root Simulation for Water Transfer in the Crop–soil System: Validation and Application

Prediction of Changes in Soil Moisture Due to Rainfall, Infiltration, and Evapotranspiration Using a Physically-Based Model

Depth-Averaged Two-Dimensional Model of Unsteady Flow and Sediment Transport Due to Noncohesive Embankment Break/Breaching

Finite Volume Method Solution of Pollutant Transport in Catchment Sheet Flow

A comprehensive mathematical model for transport of sediment and contaminants by unsteady flow in river networks

Simulating the evolution of non-point source pollutants in a shallow water environment

A Fully Coupled Depth-Integrated Model for Surface Water and Groundwater Flows

Modeling of Rainfall Induced Phosphorus Transport from Soil to Runoff with Consideration of Phosphorus-Sediment Interactions

An Approximately Semi-Analytical Model for Describing Surface Runoff of Rainwater Over Sloped Land

Modeling Contaminant Transport In A System Of Leaky Aquifers

A Unifying Transfer Model for Soil Erosion, River Bedload and Chemical Transport

Distributed Hydrological and Sediment Transport Model for Central Sichuan Hilly Areas

Assessment of Suspended Solid Removal in a Surface Flow Constructed Wetland Using a Three-Dimensional Numerical Model

A Multigrid Dynamic Bidirectional Coupled Surface Flow Routing Model for Flood Simulation