Abstract:Concrete structures are widely used in construction because of their many advantages, including high corrosion resistance, durability, low operating costs, and the ability to design any geometry. However, they also have some disadvantages, such as their high dead weight and susceptibility to cracking. Although this material is widely used globally, new types of concrete, such as high-strength or lightweight aggregate-based, are still being developed. This requires constant control and testing in both laboratory and field conditions. Concrete is a heterogeneous material due to the influence of aggregate grains and local discontinuities, voids or pores. Given these characteristics, it is clear that most conventional diagnostic solutions, such as spot foil strain gauges or extensometers, are unable to accurately analyse these localised effects as they average local strains over the measurement base. In contrast, distributed fibre optic sensing (DFOS) enables strain readings to be taken with millimetre geometric resolution, significantly extending the structural assessment capability. The article describes research on standard concrete cylinders equipped with surface-mounted optical fibres for simultaneous measurements of distributed strains in both the longitudinal direction (compression zone) and circumference direction (tension zone). The novelty of the proposed approach, apart from the way of arranging the sensing fibres on the specimens, lies mainly in the new diagnostic approach that allow (1) the evaluation of the homogeneity of the concrete using statistical parameters, (2) the identification of microcracking and (3) the identification of near-to-failure state based on Poisson's ratio analysis. Twenty cylindrical specimens were laboratory tested using reference techniques to validate the performance of the DFOS-based system and to provide data for statistical evaluation. The results indicate the possibility of detecting the approaching damage even without knowledge of the material properties of the specimen or the initial stress level at the moment of starting the measurements. The discussion also covered future research directions and potential improvements.

Circumferential Strain Measurement for a Concrete Cylinder in Uniaxial Compression by a Fiber Optic Sensor

Circumferential strain measurement of high strength concrete in triaxial compression by fiber optic sensor

Calibration of embedded fiber optic sensor in concrete under biaxial compression

Fiber Optic 2-D Sensor for Measuring the Strain Inside the Concrete Specimen

Effect of the plastic coating on strain measurement of concrete by fiber optic sensor

An Optical Fiber Sensor Method for Simultaneously Monitoring Corrosion and Structural Strain Induced by Loading

Ctod Measurement for Cracks in Concrete by Fiber Optic Sensors

Elasto-plastic Bond Mechanics of Embedded Fiber Optic Sensors in Concrete under Uniaxial Tension with Strain Localization

Model for measurement of thermal expansion coefficient of concrete by fiber optic sensor

Experimental Study of Measuring Strain by Fiber-Optic Sensor Used in Civil Engineering Structures

Elasto-Plastic Bonding of Embedded Optical Fiber Sensors in Concrete

Monitoring Flexure Behavior of Compacted Clay Beam Using High-Resolution Distributed Fiber Optic Strain Sensors

Application of Optical-Fiber Sensing to Concrete Support and Continuous Wall Strain Monitoring

Experimental Research on Monitoring Concrete Expansion and Cracking Induced by Corrosion based on Distributed Optical Fiber Sensor

Various static loading condition monitoring of carbon fiber composite cylinder with integrated optical fiber sensors

Quantitative strain measurement and crack detection in RC structures using a truly distributed fiber optic sensing system

Strain Measurement and Defect Detection with Fiber-Optic Sensors Embedded into the Cement Sample

An evaluation of a novel plastic optical fibre sensor for axial strain and bend measurements

Fiber Optic Monitoring Of Scarc Specimens With Crack Location Prediction

Structural concrete measurements: New distributed approach for standard specimens

Shear Lag Model for Embedded Interferometric Optical Fiber Sensors