Preparation of P(AN-MMA) Gel Electrolyte for Li-ion Batteries

Weihua Pu,Xiangming He,Li Wang,Zheng Tian,Changyin Jiang,Chunrong Wan

DOI: https://doi.org/10.1007/s11581-007-0155-2

IF: 2.961

2008-01-01

Ionics

Abstract:Phase inversion technique was used to prepare poly(acrylonitrile-methyl methacrylate) [P(AN-MMA)]-based microporous gel electrolyte with addition of SiO2 via in-situ composition for Li-ion batteries. The P(AN-MMA) was synthesized by emulsion polymerization and was dissolved into N,N-dimethylformamide (DMF) to form a uniform solution, while tetraethyl orthosilicate (TEOS) was added into the solution and was hydrolyzed by catalysis of alkali ammonia solution to form SiO2. Then the solution was cast onto a glass plate using a doctor blade and exposed to humidified atmosphere produced by ultrasonic humidifier, followed by washing, rinsing, and drying, successively. The gel electrolyte was obtained by putting the P(AN-MMA) microporous membrane in a liquid electrolyte. The gelled microporous membrane sucked with 755 wt% of liquid electrolyte vs the dried membrane. It had a porosity of 70%, about 1∼5 μm of pores, and presented an ionic conductivity of 0.94 × 10−3 S/cm at room temperature. Electrochemical stability window of the porous gel polymer electrolyte was determined by running a linear sweep voltammetry. The decomposition voltage of the polymer electrolyte exceeds 4.5 V vs Li. The coin test cell with the microporous gel electrolyte showed a good cycling performance. The discharge capacity retention was above 87% at 0.1 C for 45 cycles.