Abstract:An efficient finite element analysis/computational fluid dynamics (FEA/CFD) thermal coupling technique has been developed and demonstrated. The thermal coupling is achieved by an iterative procedure between FEA and CFD calculations. Communication between FEA and CFD calculations ensures continuity of temperature and heat flux. In the procedure, the FEA simulation is treated as unsteady for a given transient cycle. To speed up the thermal coupling, steady CFD calculations are employed, considering that fluid flow time scales are much shorter than those for the solid heat conduction and therefore the influence of unsteadiness in fluid regions is negligible. To facilitate the thermal coupling, the procedure is designed to allow a set of CFD models to be defined at key time points/intervals in the transient cycle and to be invoked during the coupling process at specified time points. To further enhance computational efficiency, a “frozen flow” or “energy equation only” coupling option was also developed, where only the energy equation is solved, while the flow is frozen in CFD simulation during the thermal coupling process for specified time intervals. This option has proven very useful in practice, as the flow is found to be unaffected by the thermal boundary conditions over certain time intervals. The FEA solver employed is an in-house code, and the coupling has been implemented for two different CFD solvers: a commercial code and an in-house code. Test cases include an industrial low pressure (LP) turbine and a high pressure (HP) compressor, with CFD modeling of the LP turbine disk cavity and the HP compressor drive cone cavity flows, respectively. Good agreement of wall temperatures with the industrial rig test data was observed. It is shown that the coupled solutions can be obtained in sufficiently short turn-around times (typically within a week) for use in design.

Coupled Flow-Thermal-Structural Analysis of Hypersonic Aerodynamically Heated Cylindrical Leading Edge

Dynamic Thermoelastic Analysis of A Slab Using Finite Integral Transformation Method

Numerical Simulation of Hypersonic Thermochemical Nonequilibrium Flows Using Nonlinear Coupled Constitutive Relations

Numerical Study of Heat Flux Reduction Mechanism of the Counterflowing Jet in Rarefied Flows

Numerical study of aerodynamic heating and shock detached distance for sharp leading edge

Computational Study of Lateral Jet Interaction in Hypersonic Thermochemical Non-Equilibrium Flows Using Nonlinear Coupled Constitutive Relations

Computational Simulation of Reentry Flows over Hypersonic Vehicles Using Nonlinear Coupled Constitutive Relations

Fluid-thermal-structural interaction of aerodynamically heated leading edges

Computation of Hypersonic Transitional Flows Over Cones Using Gas-Kinetic Scheme Coupled with the Turbulence Model

Partitioned Coupled Heat Transfer Fluid-Structure Interaction for Transient and Steady State Analysis of Aero Engines Applications

Heat transfer and flow structure characteristics of film-cooled leading edge model with sweeping and normal jets

Flow and heat transfer analysis of laminar flow in hypersonic aircraft with variable specific heat capacity at small attack angles

Numerical study on the non-equilibrium characteristics of high-speed atmospheric re-entry flow and radiation of aircraft based on fully coupled model

Multiphysics Coupled Fluid/Thermal/Ablation Simulation of Carbon/Carbon Composites

Investigation of aerodynamic heating in V-shaped cowl-lip of the inward turning inlet

A physical model for solving the dredging thermal protection system of hypersonic vehicle leading edge

Coupled numerical simulation on flow field and thermo-structure of composite nozzle

Coupled Fluid-Thermal-Solid Simulation of Axial Through-Flow Rotating Cavities

Thermomechanical Coupling Analysis of Heat-Pipe-cooled Leading Edge Thermal Protection Structure with Thermal Contact Resistance

Study on the influence of high-temperature thermochemical nonequilibrium effects on the flow field characteristics around shaped wing

Efficient Finite Element Analysis/Computational Fluid Dynamics Thermal Coupling for Engineering Applications