Abstract:The causes of spinal deformities—including hypoplasia of the pedicle, anatomical variations, extreme rotation, or fusion of vertebral bodies—vary, making it difficult to determine the insertion point and control the insertion angle of the pedicle screw during surgery. This study innovatively designed a 5‐point positioning point‐contact pedicle navigation template, which was used to assist in the placement of pedicle screws during spinal orthopedic surgery, and evaluated its safety, accuracy, and effectiveness during use. It was found that using the 5‐point positioning point‐contact pedicle navigation template for screw placement achieved similar results to traditional screw placement based on operator experience, with fewer complications. However, it can improve surgical efficiency, shorten operation time, reduce intraoperative blood loss, reduce surgical trauma, reduce fluoroscopy times, and reduce radiation dose during surgery. Objective Imperfect fitting of the navigation template leads to prolonged surgery time and increased blood loss. These problems have not been effectively addressed in previous research. This study explores the efficacy of a novel 5‐point positioning point‐contact pedicle navigation template in complex pedicle situations in scoliosis. Methods This study employed a retrospective controlled design. From November 2019 to November 2023, 28 patients with scoliosis and complex pedicle were selected and underwent scoliosis correction surgery. A 5‐point positioning point‐contact pedicle navigation template was used intraoperatively to guide pedicle screw placement. Matched with 56 historical cases as a control group. The analysis included screw placement time, screw placement bleeding volume, fluoroscopy frequency, manual repositioning frequency, screw placement accuracy and grade, screw placement complications, and main curve correction rate. Continuous variables were compared using the independent samples t‐test. Categorical data were analyzed with the chi‐square test. Results All 28 patients successfully underwent surgery, with a total of 268 pedicle screws placed. The surgery duration ranged from 220 to 410 min, with an average of (283.16 ± 51.26) min. Intraoperative blood loss ranged from 630 to 1900 mL, with an average of (902.17 ± 361.25) mL. Pedicle screw placement time ranged from 60 to 130 min, with an average of (85.24 ± 24.65) min. Pedicle screw placement bleeding volume ranged from 40 to 180 mL, with an average of (76.47 ± 42.65) mL. Fluoroscopy frequency ranged from 3 to 7 times, with an average of (4.31 ± 1.14) times. Manual repositioning frequency ranged from 0 to 2 times, with an average of (0.46 ± 0.58) times. Pedicle screw placement grades: Grade I: 237 screws; Grade II: 25 screws; Grade III: 6 screws; Grade IV: 0 screws. There were no screw‐related complications. The correction rate ranged from 46% to 68%, with an average of (55.83 ± 9.22)%. Compared to the experienced screw group, the differences in screw placement time, screw placement bleeding volume, fluoroscopy procedures, and manual redirections were statistically significant (p

Design of cervical pedicle locator and three-dimensional location of cervical pedicle.

Experimental study of cervical pedicle three-dimensional locator techniques

[Comparative Study Between 3D Guide Plate Assisted and Free-Hand Insertion of Anterior Cervical Transpedicular Screw].

Individualized unilateral navigation template assisting inferior cervical pedicle screw fixation

Reliability of subaxial vertebral lamina and lateral mass for the orientation of pedicle screw insertion

The Technique of Manual Placement of Pedicle Screw in the Lower Cervical Spine and the CT Scan Assessment

Comparison of the Clinical Accuracy of Cervical (C2-C7) Pedicle Screw Insertion Assisted by Fluoroscopy, Computed Tomography-Based Navigation, and Intraoperative Three-Dimensional C-arm Navigation.

Three-dimensional reconstruction visualization system enhances the accuracy of lower cervical pedicle screw implantation

[Clinical Contrast of Cervical Pedicle Screw Fixation Assisted by C-arm Fluoroscopy or 3D Navigation System].

Innovative 3D Navigation Module for Precise Unilateral Pedicle Screw Combined with Contralateral Translaminar Facet Screw Placement in Lumbar Spine Surgery

Three‐Dimensional Printing Technology Based on Digital Orthopedics: 5‐Point Positioning Point‐Contact Pedicle Navigation Template in the Case of Scoliosis and Complex Pedicle

Positioning Study of Cervical Vertebra Pedicle Axial Line Projective Point by Computed Tomography Image Reconstruction

The applied study of virtual-reality technology for accurate placement of C2 pedicle screws

Accuracy of pedicle screw placement in posterior lumbosacral instrumentation by computer tomography evaluation: A multi-centric retrospective clinical study

Design, fabrication, and evaluation of single- and multi-level 3D-printed non-covering cervical spinal fusion surgery templates

Morphometric analysis of the seventh cervical vertebra for pedicle screw insertion

Research into the anatomy of the subaxial cervical pedicle for ensuring screw insertion safety

Free-hand technique of C7 pedicle screw insertion using a simply defined entry point without fluoroscopic guidance for cervical spondylotic myelopathy patients with C3 to C6 instrumented by lateral mass screw: a retrospective cohort study

Accuracy and Safety of Lateral Vertebral Notch-Referred Technique Used in Subaxial Cervical Pedicle Screw Placement

Fully automated determination of robotic pedicle screw accuracy and precision utilizing computer vision algorithms

A Robotic System For Spine Surgery Positioning And Pedicle Screw Placement