Abstract:The micro-electro-mechanical system (MEMS) resonator developed based on surface processing technology usually changes the section shape either due to excessive etching or insufficient etching. In this paper, a section parameter is proposed to describe the microbeam changes in the upper and lower sections. The effect of section change on the mechanical properties is studied analytically and verified through numerical and finite element solutions. A doubly-clamped microbeam-based resonator, which is actuated by an electrode on one side, is investigated. The higher-order model is derived without neglecting the effects of neutral plane stretching and electrostatic nonlinearity. Further, the Galerkin method and Newton⁻Cotes method are used to reduce the complexity and order of the derived model. First of all, the influence of microbeam shape and gap variation on the static pull-in are studied. Then, the dynamic analysis of the system is investigated. The method of multiple scales (MMS) is applied to determine the response of the system for small amplitude vibrations. The relationship between the microbeam shape and the frequency response is discussed. Results show that the change of section and gap distance can make the vibration soften, harden, and so on. Furthermore, when the amplitude of vibration is large, the frequency response softening effect is weakened by the MMS. If the nonlinearity shows hardening-type behavior at the beginning, with the increase of the amplitude, the frequency response will shift from hardening to softening behavior. The large amplitude in-well motions are studied to investigate the transitions between hardening and softening behaviors. Finally, the finite element analysis using COMSOL software (COMSOL Inc., Stockholm, Sweden) is carried out to verify the theoretical results, and the two results are very close to each other in the stable region.

An iterative method for nonlinear dynamical system of an electrostatically actuated micro-cantilever

Macromodeling of the electrostatically actuated circular plate based on mode superposition method

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

Macro modeling method for electrostatic-drive silicon diaphragm

Macromodeling Of The Electrostatically Actuated Rectangle Plate Based On Modal Projection

Static and Dynamic Analysis of Electrostatically Actuated Microcantilevers Using the Spectral Element Method

Simulation methods for micro-electro-mechanical structures (MEMS) with application to a microtweezer

Coupled-field finite element analysis of MEMS compound electrostatic actuator by using the ANSYS software

Path following and numerical continuation methods for non-linear MEMS and NEMS

Modeling of Contact and Stiction in Electrostatic Microcantilever Actuators

Static Nano-Control Of Cantilever Beams Using The Inverse Flexoelectric Effect

Nonlinear dynamics of nanoelectromechanical cantilevers based on nanowire piezoresistive detection

Micro-Structronics and Control of Hybrid Electrostrictive/Piezoelectric Thin Shells

Coulomb-actuated microbeams revisited: experimental and numerical modal decomposition of the saddle-node bifurcation

Experimental Characterization of the static behaviour of microcatntilevers electrostatically actuated

Simulation studies on nonlinear dynamics and chaos in a MEMS cantilever control system

Dynamics of Electrostatic MEMS Actuators

Numerical simulation and analysis of an electroactuated beam using a radial basis function

Studying nonlinear vibration analysis of nanoelectro-mechanical resonators via analytical computational method

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error

Analysis of nonlinear dynamics of a cantilever beam-rigid-body MEMS gyroscope using a continuation method