Experiment on the filtration and back wash of sediment desilting filter of circular ring
胡浩,张林林,焦文娟,侍克斌
DOI: https://doi.org/10.13476/j.cnki.nsbdqk.2015.04.024
2015-01-01
Abstract:The experiment s on the filtration bed in the filter tank of sediment desilting filter of circular ring were conducted to in-vest igate the filtration performance of the filter layer after the design optimizat ion and backwashing effects of the filter layer af-ter the filtration period. Through the pavement and experimentof the filter layer after the design optimization, the results show ed that when the velocity was 19 m/ h and the turbidity of incoming water to be filtered was 50 NTU, the turbidity of efflu-ent was close to 0; when the turbidit y of incom ing water was 300 NTU, the turbidity of effluent was 3 NTU; and when the tur-bidity of incoming water was below 500 NTU, the turbidity of effluent was below 5 NTU, which met the standard of rough fil-tration in the rural wat er supply. Moreover, when the velocity of flow was 18. 75 m/ h, the turbidit y of incoming water to be fil-tered was about 400 NTU, the filtration cycle reached 13 hours. The filter material was clean after six times of backwashing, the difference between upstream and downstream water levels recovered to the original state, filt ration cycle was about 15 minutes, and water consumption rate was 1. 8% . The gravit y of water was applied to flush the silt and sand in the grit chamber and filter tank, and no additional pow er was needed. Therefore, the device achieved the objective of energy saving, environmental protec-tion, and high efficiency when applied to the rough filt ration of rural water supply.