Hydrogen Reconversion from Ammonia through Anion Exchange Membrane Electrolysis
Riham Kanaan,Pedro Henrique Affonso Nóbrega,Christian Beauger
DOI: https://doi.org/10.1149/ma2023-01382272mtgabs
2023-08-28
ECS Meeting Abstracts
Abstract:Nitrogen-based compounds, especially ammonia, is a promising alternative for the storage and transport of renewable hydrogen over long distances [1]. Considering ammonia as a hydrogen carrier will require studying the conversion (ammonia to hydrogen) and reconversion steps (hydrogen to ammonia). The reconversion of ammonia can take place through electrolysis under alkaline conditions [2] and needs the development of more efficient catalysts. For this, we started studying the electro-oxidation of ammonia in an anion exchange membrane electrolyser over platinum-based and PGM free electrodes with KOH as electrolyte. We have prepared several catalysts, carbon supported platinum, platinum-iridium, and nickel nanoparticles using the polyol technique. Commercial carbon supported platinum nanoparticles was used as catalyst for the cathodes. Catalyst coated substrates (CCS) were then prepared by spraying a catalytic ink over stainless-steel fiber paper for the anode side. The formulation of the ink requires optimizing parameters such as the type of ionomer (nafion, sustanion) and the ratio of ionomer to carbon. Anodes obtained have been assembled with anion exchange membranes and commercial cathodes for ammonia electro-oxidation in single cell. We have compared the performance of these different membrane electrodes assemblies (MEAs) to commercially available ones integrating nickel-iron-cobalt based anodes. The performance of MEAs was analyzed based on polarization curves, cyclic voltammograms and impedance spectroscopy data. Different testing conditions were investigated by varying the ammonia concentration from 0.1 to 1 M, the temperature from 25 °C to 60°C, and the KOH concentration from 0.1 to 5 M. References: [1] N. Morlanés et al. , “A technological roadmap to the ammonia energy economy: Current state and missing technologies,” Chem. Eng. J. , vol. 408, 2021, doi: 10.1016/j.cej.2020.127310. [2] N. M. Adli, H. Zhang, S. Mukherjee, and G. Wu, “Review—Ammonia Oxidation Electrocatalysis for Hydrogen Generation and Fuel Cells,” Journal of the Electrochemical Society , vol. 165, no. 15. pp. J3130–J3147, 2018, doi: 10.1149/2.0191815jes.