Abstract:This study presents the experimental investigation on the cavity regime and the corresponding geometric characteristic of ventilated partial cavitation (VPC). Experiments are conducted in the high-speed water tunnel at Saint Anthony Falls Laboratory. A backward-facing cavitator mounted on the ceiling of test section is used to generate the VPC. The flow filed and the dynamic motion of VPC are captured by the imaging system under varying water speeds and ventilation rates. Four distinct cavity regimes are classified, referred to as foamy cavity (FC), transition cavity (TC), open cavity (OC) and two-branch cavity (TBC). The distribution of these cavity regimes over Froude number (Fr) and ventilation coefficient (C-Qs) is summarized in a regime map with FC and TBC occupying the majority portion of the map. More importantly, the C-Qs - Fr curves demarcating neighboring cavity regimes are revealed satisfying a clear linear relation for FC-TC and a quadratic relation for TC-OC and OC-TBC when Fr is subtracted with a constant corresponding to the inception condition of the cavity regime. Such trends are attributed to the two gas entrainment mechanisms present in VPC, referred to as recirculating vortex entrainment and cavity closure entrainment. Moreover, the geometric characteristic of VPC characterized by the cavity length is examined. With increasing ventilation at fixed Fr, the cavity length grows linearly in OC regime and remains unchanged in TBC regime. The maximum cavity length of OC is found to be within around 7 times of cavitator height. With increasing Fr at fixed ventilation, the cavity length first grows proportional to Fr-2 in TBC regime but drops sharply with a small increase of Fr when the cavity transitions from TBC to OC. At fixed Fr, the cavity underpressure rises to maximum (minimum sigma(c)) and stays unchanged in TBC upon increasing ventilation. As a result, in TBC, the cavity length is shown to satisfy a power law relation with respect to Fr or sigma(c), while in OC, the cavity length is influenced by the interplay among C-Qs, sigma(c) and Fr with no clear trend observed. (C) 2019 Elsevier Ltd. All rights reserved.

Cavitation Resonance: the Phenomenon and Unknown

A Fundamental Research of Cavitation in Hydraulic Component

An Attribution of Cavitation Resonance: Volumetric Oscillations of Cloud

Fundamentals of cavitation and bubble dynamics with engineering applications

A review of cavitation in hydraulic machinery

Experimental Investigation of Ventilated Partial Cavitation

The Hydraulic Cavitation Affected by Nanoparticles in Nanofluids

Cavitation Characterization of Fluid Machinery Based on Cyclostationary Analysis: Part 1—Cavity Type Identification by Carrier Distribution

Research Progresses and Prospects of Unsteady Hydrodynamics Characteristics for Cavitation

INVESTIGATION INTO CAVITATION INDUCED NOISE WITHIN HYDRAULIC RELIEF VALVE

Wavelet-based Multiresolution Analysis of Cavitation-Induced Loading Instabilities under Phase Effect in a Waterjet Pump

Cavitation Characterization of Fluid Machinery Based on Cyclostationary Analysis: Part 2-Cavity Development Evaluation by Modulation Intensity

Thermodynamic effects at Venturi cavitation in different liquids

Experimental and Numerical Investigations of Hydraulic Resonance Characteristics of a High-Frequency Excitation System

Numerical Investigation of the Cavitation Dynamic Parameters in a Francis Turbine Draft Tube with Columnar Vortex Rope

Cavitation in soft matter

Investigation on cavitation initiation in jet pump cavitation reactors with special emphasis on two mechanisms of cavitation initiation

Instabilities of Blow-Down Type Venturi Cavitation Considering Thermodynamic Effect

Numerical Simulation of Ventilated Cavitation Evolution with an Insight on How Ventilation Influences Pressure Fluctuation and Cavitation Noise

Cavitation pressure fluctuation characteristics of a prototype pump-turbine analysed by using CFD

Modeling and Scaling of Cavitation Compliance in Venturi