Abstract:Timely detection of the occurrence of cavitation in pumps is very important as it can cause pitting, erosion, and loss of pump performance. Attempts to determine a unique signature of cavitation using vibration, acoustic emission [1] [2], audibleacoustics [3], and higher order non-linear modeling [4] techniques have been elusive. This paper presents the results of an experimental study undertaken first to understand the structure of cavitation and develop an effective means for on-line detection of it. Tests were performed to measure vibration, pressure, audible sound, motor current and the force due to cavitation of a centrifugal pump. A special force transducer capable of measuring fluctuating forces exerted by cavitation process on the pump casing was developed to understand the dynamics of cavitation phenomenon and signatures of a centrifugal pump operating under different cavitation conditions. Two of the abnormal operating conditions studied were the formation of tiny air bubbles (initiation of cavitation) and then fully developed cavitation. Experiments were also run with a transparent LEXAN cover using colored water to observe the cavitation. A Video was also taken for observing and developing an understanding of cavitation mechanism. Vibration, force, audible sound, and dynamic pressure were analyzed to detect cavitation. It was found that the pump has higher vibration amplitude in the axial direction than in the radial direction. This may be due to lower stiffness in the axial direction. From the experiments, it was also determined that significant amount of air bubbles will increase vibration component associated with the impeller vane pass frequency. Cavitation seems to excite high frequency structural resonances. Also, a fully developed cavitation may reduce the impeller vane pass frequency vibration amplitude. The force spectra did not provide any measurable information of cavitation.

Cavitation Characterization of Fluid Machinery Based on Cyclostationary Analysis: Part 1—Cavity Type Identification by Carrier Distribution

Cavitation Characterization of Fluid Machinery Based on Cyclostationary Analysis: Part 2-Cavity Development Evaluation by Modulation Intensity

A carrier wave extraction method for cavitation characterization based on time synchronous average and time-frequency analysis

An intelligent detecting approach of incipient cavitation based on fast kurtogram

Wavelet-based Multiresolution Analysis of Cavitation-Induced Loading Instabilities under Phase Effect in a Waterjet Pump

An Adaptive Autogram Approach Based on a CFAR Detector for Incipient Cavitation Detection.

Cyclostationary Approach to Detect Flow-Induced Effects on Vibration Signals from Centrifugal Pumps

Experimental Investigation of Tip Vortex Cavitation Noise under Static and Dynamic States

The Characteristics of Unsteady Cavitation Around a Sphere

Fundamentals of cavitation and bubble dynamics with engineering applications

Research on the Cavitation Identification of Kaplan Turbine Using Acoustic Signals

Dynamic Behaviors of Blade Cavitation in a Water Jet Pump with Inlet Guide Vanes: Effects of Inflow Non-Uniformity and Unsteadiness

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

A Lagrangian Analysis of Partial Cavitation Growth and Cavitation Control Mechanism

Research Progresses and Prospects of Unsteady Hydrodynamics Characteristics for Cavitation

Cavitation identification in a hydraulic bulb turbine based on vibration and pressure fluctuation measurements

Cavitation Monitoring System Based on Surface of Critical Cavitation Coefficient

Using Vibration Signatures Analysis to Detect Cavitation in Centrifugal Pumps

Data-driven insights into cavitation phenomena: From spatiotemporal features to physical state transitions

On unsteady cavitation flow of a high-speed submerged water jet based on data-driven modal decomposition

Detection of Erosive Cavitation on Hydraulic Turbines Through Demodulation Analysis