In-situ Formatting Composite Coating by Laser Cladding C+BN Power on TC4 Alloy

蒋松林,陈志勇,朱卫华,林英华,何彬,李月华,王新林

DOI: https://doi.org/10.3969/j.issn.1001-5078.2010.05.002

2010-01-01

Abstract:The mechanical mixed C+BN powders were cladded on the surface of TC4 alloys by transverse flow CO2 laser,and hard composite coating was in-situ formatted.The microstructure of clad layers were observed and analyzed by Optical Microscope(OM),Scanning Electronic Microscope(SEM)and Energy Dispersive X-ray spectroscope(EDXs).The microhardness of clad layers was measured.The results show that clad layers with fine interdendritic crystal are in-situ formed successfully by laser cladding with the precursor mixture of carbon,boron nitride(C+BN)powders.The metallurgical combining interface between the clad layer and substrate is achieved and the highest microhardness of clad layers is reached to 1454 HV0.5,leading to remarkable surface hardness enhancement of the TC4 alloy.