Abstract:Grinding force model is an important tool for the selection and optimization of ultrasonic-assisted grinding of advanced ceramics. Meanwhile, there is still a lot of room for performance improvement and application expansion. In particular, it is generally recognized that the grinding wheel wear state directly affects the accuracy of grinding force model. To address these issues, a model for predicting the grinding force during ultrasonic-assisted face grinding (UAFG) of advanced ceramic materials was proposed in the present work based on the material removal mechanisms and the friction characteristics of the grain–workpiece interface under the action of ultrasonic vibration. UAFG tests were carried out on ZrO 2 ceramics to verify the accuracy of the model. The results show that the average discrepancies between the predicted and measured normal and tangential forces are 7.4% and 8.1%, respectively. Finally, the tool wear tests reveal that with the gradual wear of the tool, the grinding force first decreases and then increases, and the accuracy of the model follows the opposite trend. Furthermore, the abrasive wear state has a significant effect on the surface material removal mechanism during ultrasonic-assisted grinding. When the cutting-edge morphology is regular and micro-crushed abrasive grains are predominant, the material removal mechanism is a combination of plastic removal and brittle fracture. When macro-crushed abrasive grains and abrasive fracture prevail, the material removal mechanism is dominated by brittle fracture, while the material removal mechanism is dominated by plastic removal when abrasive platform is predominant.

Study on the Sign of Wear and Tear in Working Stones by Grinding Wheel

A Technological Study on Granite Grinding

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Wear Behaviors of Pcd Tools in Turning Granite

Experimental Study on Relation between Tool Wear and Grinding Force for Shaping Diamond Tool

Wear Rule of Single Diamond Grit when Scratching on Engineering Ceramics

Study on Wear Behaviors and Grain Effects of Pcd Cutting Tools in Turning Granite

The Influence Of Special-Shaped Stones Machining Parameters On Wear Performance Of Metal Bonded Diamond Grinding Wheel

The Experimental Investigation of Stone Wear in Honing

Research on the Laws of Wear Rate of Grinding Block in Grinding SiC

Wear Mechanism of Diamond Mills in Stone Cutting

Mechanism Analysis and Experimental Research on Wear of Electroplated Diamond Micro-grinding Tool

Study on cutting performance of ceramic rock slab machined by rotating ultrasonic vibration

Research on Grinding Block Wear in Grinding of SiC

The Experimental Research of the Relationship Between Rock Surface Roughness and PDC Bit Wear

Experimental Investigation on the Effects of Tool Geometry and Cutting Conditions on Machining Behavior during Edge Finishing of Granite Using Concave and Chamfered Profiling Tools

Grinding Wheel Wear in Grinding of High Hardness Spherical Surface with Cup Wheel

Grinding force modeling in ultrasonic-assisted face grinding of ZrO2 ceramics and influence of grinding wheel wear on its accuracy

Investigation of Machining and Wear Performance of Various Diamond Micro-Grinding Tools

Study on Edge Contact Area and Surface Integrity of Workpiece in Point Grinding Process

The Influence of Grain Geometry and Wear Conditions on the Material Removal Mechanism in Silicon Carbide Grinding with Single Grain