Abstract:As a result of a collaboration between Jefferson Lab and niobium manufacturer CBMM, ingot niobium was explored as a possible material for superconducting radiofrequency (SRF) cavity fabrication. The first single cell cavity from large grain high purity niobium was fabricated and successfully tested at Jefferson Lab in 2004. This pioneering work triggered research activities in other SRF laboratories around the world. Large grain niobium became not only an interesting alternative material for cavity builders, but also material scientists and surface scientists were eager to participate in the development of this material. Most of the original expectations for this material of being less costly and allowing less expensive fabrication and treatment procedures at the same performance levels in cavities have been met. Many single cell cavities made from material of different suppliers have been tested successfully and several multi-cell cavities have shown the performances comparable to the best cavities made from standard poly-crystalline niobium. Several 9-cell cavities fabricated by Research Instruments and tested at DESY exceeded the best performing fine grain cavities with a record accelerating gradient of Eacc = 45.6 MV/m. Recently- at JLab- by using a new furnace treatment procedure a single cell cavity made of ingot niobium performed at a remarkably high Q0-value (~5x10^10) at an accelerating gradient of ~20 MV/m, at 2K. Such performance levels push the state-of-the art of SRF technology to new limits and are of great interest for future accelerators. This contribution reviews the development of ingot niobium technology and attempts to make a case for this material being the choice for future accelerators.

Development of a Prototype Niobium SRF Cavity for the PEFP Proton Superconducting Linac

Rf superconductivity activities of pefp*

Industrial Fabrication of Medium-Beta SCRF Cavities for a High-Intensity Proton Linac

Development of a prototype superconducting radio-frequency cavity for conduction-cooled accelerators

Fabrication and cold test of prototype of spatially periodic radio frequency quadrupole focusing linac

DESIGN OF THE PEFP LOW BETA CRYOMODULE

Development and Measurements of A Technological Cavity for 350mhz High Current Proton Rfq

Design of a 162.5 MHz Superconducting Radio-Frequency Quadrupole for High-Intensity Proton Acceleration

Control and Measurement System for the Tuning of A Pefp Low-Beta Superconducting Rf Cavity

Development Of High Purity Niobium Used In Srf Accelerating Cavity

Fabrication and Evaluation of Superconducting Single-Cell Cavities Manufactured Using Various Materials and Methods

Design study of a beta=0.09 high current superconducting half wave resonator

3.5-cell large grain niobium superconducting cavity for a dc superconducting rf photoinjector

Studies of LL-type 500MHz 5-cell superconducting cavity at SINAP

R&D OF NIOBIUM-SPUTTERED COPPER QWR FOR HEAVY ION LINAC IN PEKING UNIVERSITY

Superconducting RF Deflecting Cavity Design and Prototype for Short X-ray Pulse Generation

Electromagnetic Design and Optimization of a Superconducting Quarter Wave Resonator

The Rise of Ingot Niobium as a Material for Superconducting Radiofrequency Accelerating Cavities

High-gradient performance of a prototype accelerator cavity for a 3 GeV proton radiography booster

Multipacting Behavior Research in a PEFP Low-Beta Superconducting RF Cavity and in a PEFP Fundamental Power Coupler

Feasibility Study on SRF Cavity Improvement by Doping Method