Abstract:Asynchronous circuits with low power and robustness are revived in emerging applications such as the Internet of Things (IoT) and neuromorphic chips, thanks to clock-less and event-driven mechanisms. However, the lack of mature computer-aided design (CAD) tools for designing large-scale asynchronous circuits results in low design efficiency and high cost. This article proposes an end-to-end bundled-data (BD) asynchronous circuit design flow, which can facilitate building asynchronous circuits, even if the designer has little or no asynchronous circuit foundation. Three features that enable this are: 1) a lightweight circuit converter developed in Python can convert circuits from synchronous descriptions to corresponding asynchronous ones at register transfer level (RTL). Desynchronization flow helps designers maintain a "synchronization mentality" to construct asynchronous circuits; 2) a synchronization-like verification method is proposed for asynchronous circuits so that it can be functionally verified before synthesis. Avoids the risk of rework after logic defects are discovered during the synthesis and implementation, as asynchronous circuits often cannot be simulated until gate-level (GL) netlist generation; and 3) the whole implementation flow from RTL to graphic data system (GDS) is based on commercial electronic design automation (EDA) tools. Similar to the design flow of synchronous circuits, it helps designers implement asynchronous circuits with "synchronization habits." Furthermore, to validate this methodology, two asynchronous processors were, respectively, implemented and evaluated in the TSMC 28-nm CMOS process. Compared to their synchronous counterparts, the general-purpose asynchronous RISC-V processor achieves 20.5% power savings. And the domain-specific asynchronous spiking neural network (SNN) accelerator achieves 58.46% power savings and 2.41x energy efficiency improvement at 70% input spike sparsity.

Asynchronous Circuits Design of LCD Controller

A Novel Bias Circuit Design in Low Power Lcd Driver

P-232L: Late-News Poster: New Results on Bistable Photoaligned Ferroelectric LCDs: Grey Scale Generation, Stabilization and Passive Driving Scheme

The Design and FPGA Verification of TFT-LCD Timing Controller

Circuit Design of Single Panel Color LCOS Microdisplay Chip

Towards Energy-Efficient Asynchronous Circuit Design with Flip-Flop-to-Latch Replacement

Asynchronous Techniques for System-on-Chip Design

Technique for Asynchronous Clocks in Video Signal Processing SoC

120Hz low cross-talk stereoscopic display with intelligent LED backlight enabled by multi-dimensional controlling IC

LAC: A Novel Lightweight Asynchronous Controller with Optimized Phase Shift

An Asynchronous Design Method and Its Application on a Low-Power RFID Baseband Processor

Realization of Dynamic Local Refresh on Liquid Crystal Display with Novel Partial Scan Gate Driver on Array

Design of Soft Start Energy-Saving Controller of Asynchronous Motor

An End-to-End Bundled-Data Asynchronous Circuits Design Flow: from RTL to GDS

Toward Efficient Asynchronous Circuits Design Flow Using Backward Delay Propagation Constraint

Study of Pixel and Driving Circuits of OLED on Silicon

Study and reduction of waterfall effect caused by dimming backlight in LCD based on amorphous silicon TFT

Improving The Processing Speed Of An Lcd Panel Based Correlator By Using A Multi-Channel Correlation Approach

A Design Flow for Click-Based Asynchronous Circuits Design with Conventional EDA Tools.

Design of LCD Driver Chip with 1024-Level Gray Scale and Large Capacitor Load

Design and Implementation of Ultra-Low Power I2C-Compatible Bus based on Asynchronous Circuit