Abstract:The present paper focuses on the heat transfer and contact pressure at the casting-die interface in squeeze casting process. Experiments were conducted and a "plate shape" was used to cast aluminum alloy A356 in H13 steel die. Based on the temperature measurements inside the die, the interfacial heat transfer coefficient (IHTC) at the metal-die interface was determined by applying an inverse approach. The pressure at the metal-die interface was measured by using Kistler pressure transducer. The acquired data were processed by a low pass filtering method based on Fast Fourier Transform (FFT). Besides, a set of methods was set up to verify the computer program for the inverse model. The results show that the pressure at the casting-die interface and the IHTC rose to the peak value almost simultaneously as soon as the pressure was applied by the press. The higher the applied pressure, the higher the peak value of the IHTC and the pressure at the casting-die interface. It was a pressure maintaining stage immediately after the pressure was applied. During this stage, the pressure at the casting-die interface decreased immediately after it reached the peak value. The IHTC sharply dropped at the beginning. Then, the decrease rate of the IHTC became lower and lower. Besides, the IHTC of the cases with pressure applied was much higher than those without pressure applied. It indicates that the applied pressure greatly improved the contact status of casting and die surfaces and reduced the thermal resistance between the two surfaces. The IHTC profiles of the cases with the pressures 23 MPa and 46 MPa applied did not make much difference, however, when the applied pressure reached 70 MPa, the influence of the pressure at the casting die interface on the IHTC became very remarkable. (C) 2017 Elsevier Ltd. All rights reserved.

Experimental Study and Theoretical Analysis on Die Soldering in Aluminum Die Casting

The Need for a New Approach to Soldering in High Pressure Die Casting

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Investigation on Surface Defects Produced in Pretreatment of Die-casting AM60B Magnesium Alloy

Effect of Die Size and Die Tilt on Solder Reliability under Thermal Cycling

Formation Mechanism of the Microstructural Heterogeneity in a Die-Cast Al-Mg-Si Alloy and Its Effect on Mechanical Properties

Experimental and simulation study for rewelding defects during the flow process of Semi-solid die casting

The molding analysis of automobile parts using the die-casting system

Casting defects and microstructure distribution characteristics of aluminum alloy cylinder head with complex structure

Laboratory Testing to Characterize the Use of PVD Coatings and Alternate Die Materials for Reducing Soldering and Erosion for Aluminum Die Casting Applications

Numerical Studies of Flow-Induced Defects in Aluminum Ingot Die Casting Process

Characteristic morphologies that cause failure of Au80Sn20/AlN substrate solder joint under combined temperature cycle and current switch cycle tests

Computation Method for Mechanical Performances of Die-Cast Aluminum Alloys Based on Non-Uniform Material Properties

Failure Analysis ofIn/AuSolder Joints

Experimental Study on the Heat Transfer Behavior and Contact Pressure at the Casting-Mold Interface in Squeeze Casting of Aluminum Alloy

Numerical Simulation and Experimental Study on Semi-solid Forming Process of 319s Aluminum Alloy Test Bar

On the characterization of microstructure and fracture in a high-pressure die-casting Al-10 <i>wt</i>%Si alloy

Study on Macro- and Micromodeling of the Solidification Process of Aluminum Shape Casting

Fracture Analysis of Die-casting Mould for Water Pump

Effect of Mg Content on the Shear Strength of Al-Si-Mg and Al-Si-Cu Alloys at Elevated Temperatures

The Two-Phase Flow Simulation and Experimental Research on the Formation of Solder Voids in Power Module