Abstract:In China, research on winter heating and energy saving for residential buildings mainly focuses on urban residences rather than rural ones. According to the 2018 China Building Energy Consumption Research Report, rural residential buildings emit about 423 million tons of carbon, accounting for 21% of the country’s total carbon emissions. According to the research on China’s greenhouse gas inventory, the main sources of carbon emissions in rural areas are from cooking and the burning of fuelwood and biomass for heating in winter. In this study, the southern Shaanxi area, which is hot in summer and cold in winter, was selected as the research site, and a fire wall system was planned that combines cooking and heating facilities in residential buildings. The system uses the heat generated by cooking and the heat storage capacity of the wall, as well as the principle of thermal radiation and heat convection, to increase the indoor temperature. The advantage is that the hot air generated is mainly concentrated in the inside of the wall, which reduces the direct contact with the cold outdoor air and avoids excess heat loss. In this study, in addition to considering the influence of the cooking fire wall system on the indoor temperature, the difference in the outer wall with or without solar thermal radiation was also considered. The research results show that the use of a cooking fire wall heating system reduces the annual heat load of the building to 440.8318 KW·h, which is a reduction rate of 7.91%. When there is solar radiation on the outer wall, the annual thermal load of the building is reduced by 1104.723 kW·h, and the reduction rate is 19.84%.

Experimental Study on the Thermal Performance of Hot-wall Type Kang

The Energy Saving Effect of Different Wall Insulation Configurations with the Intermittent and Compartmental Heating Method

Experimental research on thermal performance of thermal circulatory aerial heated kang of rural residence in severe cold regions

A New Chinese Kang with Forced Convection: System Design and Thermal Performance Measurements

Improving the Thermal Performance of the Traditional Chinese Kang System by Employing Smoldering Combustion and Mechanical Ventilation: an Experimental Study

Thermal and Energy Analysis of a Chinese Kang

Study on indoor temperature and thermal performance of a novel solar coupled floor and Kang heating system

Experimental Assessment of Thermal Performance of an Elevated Chinese Kang System

Experimental and Numerical Research on the Performance of an Energy-Saving Elevated Kang in Rural Buildings of Northeast China

Thermal Performance of a Novel Heating Bed System Integrated with a Stack Effect Tunnel

The Thermal Effect of the Tandem Kang Model for Rural Houses in Northern China: a Case Study in Tangshan

Experimental on a Novel Solar Energy Heating System for Residential Buildings in Cold Zone of China

The traditional Chinese kang and its improvement: A review

Experimental Study of A Combined System of Solar Kang and Solar Air Collector

Study on thermal storage performance of solar KANG and thermal comfort for sleeping environments

Experimental Investigation on Contacting Heating System Assisted by Air Source Heat Pump in Residential Buildings

Study on the Passive Heating System of a Heated Cooking Wall in Dwellings: A Case Study of Traditional Dwellings in Southern Shaanxi, China

Thermal Analysis of a New Solar Kang System

Experimental and simulation study on the thermal performance of a novel flue composite wall

A Study on Thermal Performance, Thermal Comfort in Sleeping Environment and Solar Energy Contribution of Solar Chinese Kang

Experimental Evaluation of a Capillary Heating Bed Driven by an Air Source Heat Pump and Solar Energy