Abstract:Purpose A 3D finite element (FE) model based on the double ellipsoidal heat source was developed to investigate the evolution of temperature and stress fields during the multilayer and multi-pass wire and arc additive manufacturing (WAAM) process. This paper aims to investigate the evolution of temperature and stress fields during the multilayer and multi-pass wire and arc additive manufacturing (WAAM) process by developing a 3D finite element (FE) model based on the double ellipsoidal heat source. Design/methodology/approach Experimental thermal cycle curves and residual stresses were obtained by thermocouples and X-ray diffraction, respectively. The validity of the model was verified by the corresponding experimental results. Findings The deposition process of the upper pass led to the partial remelting of the lower deposited pass. The thermal process of the current-deposited pass alleviated the stress concentration in the previous-formed passes. A more uniform temperature distribution could be obtained by using the reciprocating deposition path. Compared to the reciprocating deposition path, the peak values of the transverse and longitudinal tensile residual stresses of the deposited sample under the unidirectional deposition path were reduced by 15 MPa and increased by 13 MPa, respectively. The heat conduction in the deposited passes could be improved by extending the inter-pass cooling time appropriately. With an increase in the inter-pass cooling time, the longitudinal residual stress in the middle region of sample along longitudinal and transverse directions showed increase and decrease–increase trends, respectively, while the transverse residual stress exhibited decrease trend. Originality/value This study enhances the understanding of temperature and stress fields evolution during the multilayer and multi-pass cold metal transfer-WAAM processes of magnesium alloy and provides the reference for parameter optimization.

Numerical Simulation Research of Hot Deep Drawing for Magnesium Alloy Sheet

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Numerical Simulation of Hot Stamping Forming of AZ Series Magnesium Alloys and Optimization of Die Process

Study on the hot deep drawing performance and microstructural evolution of AZ91D magnesium alloy sheets

Numerical Modeling of Magnesium Alloy Sheet Metal Forming at Elevated Temperature

Numerical and Experimental Investigation on Hot Backward Extrusion Process of Mg-Gd-Y-Zn-Zr Magnesium Alloy

Numerical simulation and experimental study of warm hydro-forming of magnesium alloy sheet

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Stress and Distortion Simulation of Magnesium Alloy Die Casting Dies

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Modeling material behavior of AA5083 aluminum alloy sheet using biaxial tensile tests and its application in numerical simulation of deep drawing

A New Equation of Load Curve of Critical Wrinkles Variable Blank Holder Force in the Warm Deep-Drawing of Twin-Roll Cast Mg Sheets

A Novel Method for Friction Coefficient Calculation in Metal Sheet Forming of Axis-Symmetric Deep Drawing Parts

Finite Element Modeling for Deep-Drawing of Aluminum Alloy Sheet 6014-T4 Using Anisotropic Yield and Non-Afr Models

Integrated Physical and Numerical Simulations of Weld Seam Formation During Extrusion of Magnesium Alloy

Experimental Study of Hot Deep Drawing for Twin-Roll-cast AZ31 Alloy

Experimental and numerical investigation into rectangular tube extrusion of high-strength magnesium alloy

FEA Modelling and Analysis of Die Casting Machine for Large Mg Alloy

Numerical simulation of the residual stress in the Mg-5Zn-3.5Sn-1Mn-0.5Ca-0.5Cu alloy with different extrusion parameters

Finite Element Simulation of Two Stroke Deep Drawing in Sheet Metal Forming

Numerical simulation of thermal and stress fields for multilayer and multi-pass weaving WAAM of magnesium alloy