Abstract:A heat exchanger is an important component where high-temperature hot air and normal-temperature water exchange heat. The heat exchange area of the finned tube heat exchanger is calculated by the rated working conditions. However, with the decrease of the heat storage temperature, the hot air temperature at the outlet of the thermodynamic energy storage device changes in a large range, directly affecting the heat exchange capacity and efficiency of the finned tube heat exchanger. This paper's three-dimensional model is established. The heat exchanger of the finned tube is designed according to the temperature of the outlet section and the return section temperature of the heat storage system. The thermodynamic physical parameter property and characteristics of which heat exchanger's finned tube in the air's velocity range of 1∼10 m/s are simulated by fluent software. The velocity, temperature, pressure, and heat exchanger coefficient distribution characteristics at different positions along the airflow direction are obtained. The simulation results show that the mean flow velocity is 2.0 m/s and 5.0 m/s at the inlet cross-section. The average temperature difference between the inlet and outlet is 69.5 K and 100.5 K, respectively. The fin surface temperature difference between the first and eighth rows of finned tubes is 12.5 K and 14.4 K, respectively. The air pressure loss at the air channel inlet's section and outlet's section is 16.1 Pa and 69.4 Pa, respectively. When the inlet flow rate change from starting at 1.0 m/s and ending at 10.0 m/s, the tube's wall coefficient of heat transfer, which is the second level of finned tubes, only increases by 1.8 times. The tube's wall coefficient of heat transfer of the eighth level of finned tubes increases by the maximum, to 5 times the original, but the heat energy exchange capacity of which the second level of finned tubes is always the strongest.

Research Three Simulation Models for Fin and Tube Exchanger Used by Air Handle Unit

Numerical Simulation and Analysis of Performance of Fin-and-tube Heat Exchanger with Complex Circuit Arrangement

Numerical Simulation of Heat Transfer in Finned Tube of Heat Recovery Unit Using Fluid-Solid Coupled Method

Numerical Simulation of Heat Transfer Characteristics of Finned Tube Heat Exchanger at Different Flow Velocities

Performance Simulation and Structure Optimization for Fin -tube Heat Exchanger in Air Handle Unit

Simulation of Fin-and-tube Heat Exchanger Based on Two-phase Fluid Network

Model Analysis on the Performance of Fin-tube Heat Exchanger with Variable Condition/Structure

A General Simulation Model for Performance Prediction of Plate Fin-and-tube Heat Exchanger with Complex Circuit Configuration

3D Numerical Simulation on Fluid Flow and Heat Transfer Characteristics in Multistage Heat Exchanger with Slit Fins

A digital designing for fin and tube exchanger based on lumped models

A New Heat Transfer Model for Single U-pipe Ground Heat Exchanger

Simulation Study on Fin-tube Condenser

Numerical Investigation on Fin-Tube Three-Fluid Heat Exchanger for Hybrid Source HVAC&R Systems

Three Dimensional Numerical Simulation of Frost Formation on Finned Tube Heat Exchanger

The simulation and analysis of fin-tube evaporator for air-conditioning

Prediction and analysis of thermal-hydraulic performance with slit fins in small diameter (3 mm to 4 mm) heat exchangers

Three-Dimensional Numerical Simulation on the Laminar Flow and Heat Transfer in Four Basic Fins of Plate-Fin Heat Exchangers

Numerical Estimation of Heat Transfer Characteristics for Two-Row Plate-Finned Tube Heat Exchangers with Experimental Data

Optimum Design Of Two-Row Slotted Fin Surface With X-Shape Strip Arrangement Positioned By "Front Coarse And Rear Dense" Principle, Part I: Physical/Mathematical Models And Numerical Methods

Dynamic Modeling And Simulation Of Distributed Parameter Heat Exchanger

THREE-DIMENSIONAL NUMERICAL SIMULATION OF TURBULENT FLOW AND HEAT TRANSFER CHARACTERISTICS IN SHELL SIDE OF SHELL-AND -TUBE HEAT EXCHANGERS