Abstract:<p>The paper presents the numerical investigations for a light civil helicopter fuselage with the purpose of reducing the helicopter drag. Two numerical methods: Reynolds-Averaged Navier-Stokes (RANS) and a hybrid RANS-LES method: improved delayed detached-eddy simulation (IDDES) method are performed for the simulation of a prototype helicopter fuselage. The RANS method is validated by a modular helicopter fuselage with experimental data, while the IDDES method has already been used in other studies and good results have been achieved. The numerical results of the civil helicopter in terms of the aerodynamic coefficients obtained by the two methods are consistent with each other. Compared to the RANS method, the IDDES approach is capable of predicting the large separation flow of the fuselage/components and the small-scale vortices in the flow field. It is found that the hybrid method captures the periodically detached separating vortices behind the skid struts, while the flow at the same position simulated by the RANS method is still attached. Moreover, separating vortices, which develop diagonally upwards, are captured at fuselage/tail-boom junction by the hybrid method, whereas RANS simulation doesn't predict. Subsequently, the design of the helicopter drag reduction is carried out at <span class="math"><math>α=0</math></span> deg angle of attack and 0.2 Mach number through shape optimization based on the numerical simulations, and the numerical results are verified by the force tests. It shows that the optimization of the landing skids aims at reducing the strong Karman vortex shedding effect induced by the skids, which greatly decreases the total drag. Combined with the optimization of the fuselage/tail-boom transition, this approach suppresses the separation flow of the fuselage and reduces the pressure drag, and the adjustment of transition slope benefits of up to 1.18% drag reduction, while the extension of transition reduces the drag by 2.64%. The optimization of tail-boom layout demonstrates that lower tail-boom layout can contribute to a drag reduction by 4.37% (RANS) and 3.89% (test), respectively, when compared to the original tail-boom layout.</p>

Simulation Analysis of Effect of Typical Angels on Automotive Aerodynamic Drag

CFD Analysis on Effect of Front Windshield Angle on Aerodynamic Drag

On the aerodynamic effects of the optimised DrivAer fastback model car under adverse situations

Simulation Analysis for Effect of Rear Structure of Hatchback Car on Rear Field Characteristics

Numerical study of aerodynamic heating and shock detached distance for sharp leading edge

Study of the automotive aerodynamic performance affected by entrance structure of forecabin

Extended Study of Full-Scale Wind Tunnel Test and Simulation Analysis Based on DrivAer Model

Introduction of a New Car Model Series for Aerodynamics Research

Analysis of Automobile Air Drag Coefficient

Simulation The Effect of Spoiler on Aerodynamic for Sedan Car

Optimization of aerodynamic drag reduction for vehicles with non-smooth surfaces and research on aerodynamic characteristics under crosswind

On the Drag Reduction Optimization of the DrivAer Fastback Model Car with Digital Side Mirror

Aerodynamic Drag Features on Automobile with Non-smooth Surfaces

Comparison and Analysis on the Impact of Two Typical Rearview Mirrors on Aerodynamic Performance

Aerodynamics Analysis of UniMAP Automotive Racing Team Formula SAE Race Car spoiler via Simulation: Effect of Angle of Attack

Numerical Simulation for the Exterior Flow Field Around a Round-roof Van and Optimization Design of its Aerodynamic Attachment

Fluid Structure Interaction Simulations Applied to Automotive Aerodynamics

Aerodynamic simulation on roof-mounted intelligent awareness system of intelligent vehicle

Numerical investigation on the effect of rear wing on aerodynamic performance of race car

Numerical investigations on drag reduction of a civil light helicopter fuselage

Evaluation of wind tunnel interference on numerical prediction of wheel aerodynamics