Abstract:Using cyclic voltammetry (CV), reflectance anisotropy spectroscopy (RAS), and in situ electrochemical scanning tunneling microscopy (EC-STM), we have studied the structure and structural transitions at a Cu(110) electrode surface in 10 mM HCl solution as a function of the applied electrode potential. While at potentials lower than −550 mV vs Ag/AgCl the in situ STM images reveal the adsorbate-free, unreconstructed structure of the Cu(110) surface, at increasing potential ≥ −550 mV chloride adsorption, as indicated by CV, leads first to the formation of grooves followed by the growth of added stripes. Both are aligned in the [001] direction as shown by EC-STMand supported by ex situ low energy electron diffraction (LEED)and are the result of a severe but fully reversible restructuring of the surface. This faceting is accompanied by an optical anisotropy peak in RAS centered at about 500 nm (2.48 eV), having a maximum when the linearly polarized light is aligned along the [11̅0] direction, i.e., perpendicular to the stripes detected with in situ STM under the same conditions. By cycling the electrode potential through a full cyclic voltammogram and monitoring simultaneously the RAS signal we obtain a hysteresis-like curve which supports a two-step kinetics of the restructuring process in agreement with the CV and STM data. The investigations demonstrate the power of combined RAS and in situ STM measurements to shine light on potential-driven processes at metal–electrolyte interfaces.

Kinetics Of A Potential Induced 23x-Root-3 To 1x1 Transition Of Au(111) Studied By Insitu Scanning Tunneling Microscopy

Kinetics of a potential induced 23 × 3 to 1 × 1 transition of Au(111) studied by in situ scanning tunneling microscopy

The Kinetics of Phase Transitions in Underpotentially Deposited Cu Adlayers on Au(111)

Observations of the 22×√3 Reconstruction of Au(111) under Aqueous Solutions Using Scanning Tunneling Microscopy

Structural Phase Transition in Self-Assembled 1,10′ Phenanthroline Monolayer on Au(111)

Dynamics of the Dissolution of an Underpotentially Deposited Cu Layer on Au(111): a Combined Time-Resolved Surface-Enhanced Infrared and Chronoamperometric Study

Atomic and electronic structure of (root 3x root 3)R 30 degrees-In phase on Cu(111)

Potential-Induced Phase Transitions in 2,2‘-Bipyridine and 4,4‘-Bipyridine Monolayers on Au(111) Studied by<i>in Situ</i>Scanning Tunneling Microscopy and Atomic Force Microscopy

Assembly of Au-Cluster Superstructures by Steering the Phase Transitions of Electrochemical Adsorbate Structures

Surface-induced Symmetry Reduction in Molecular Switching: Asymmetric Cis-Trans Switching of CH3S-Au-SCH3 on Au(111).

Orientational Phase Transition in A Pyridine Adlayer on Gold(111) in Aqueous Solution Studied by in Situ Infrared Spectroscopy and Scanning Tunneling Microscopy

In Situ Scanning Tunneling Microscopy Study of Iodine and Bromine Adsorption on Gold(111) under Potential Control

Cu(110) Surface in Hydrochloric Acid Solution: Potential Dependent Chloride Adsorption and Surface Restructuring

Scanning Tunnelling Microscope Tip-Induced Reconstruction On Si(111) Root 3 X Root 30 Degrees-Ag Surface

Potential-Induced Phase Transition of N-Isobutyryl-L-cysteine Monolayers on Au (111) Surfaces

Au(111) 23×√3 Surface As a Test Surface for Comparing the Atomic Force and Scanning Tunneling Microscopes

Atomic and Electronic Structure of (3×3)R30°-in Phase on Cu(111)

Structural Dynamics Induced by Self-Assembled Monolayers on Au(111)

Manipulating the charge state of Au clusters on rutile TiO2(110) single crystal surfaces through molecular reactions probed by infrared spectroscopy

CO-induced lifting of Au (001) surface reconstruction

Resonant charge-transfer in grazing collisions of H$^-$ with vicinal nanosurfaces on Cu(111), Au(100) and Pd(111) substrates: A comparative study